APC MXA002 Datasheet download pdf (Page 14)

Battery Pack coupler

Battery Packs are connected at this coupler. A coupler clamp is installed over the

coupler opening as furnished from the factory. See the Installation section for

instructions on how to lock mated couplers.

Accessory panel

The EU is furnished with an opening that accepts accessories that work with the UPS.

Call your dealer or the factory for information on available accessories.

Computer interface port

See the UPS Monitoring section of this manual for information on this interface port.

Battery communications jack

The Battery Pack communications cable from the Battery Pack OUTPUT is connected

at this jack.

Manual bypass switch

Pressing the manual bypass switch causes the UPS to transfer to the bypass mode of

operation. While in this mode, the load is supplied with power conditioned by the

IU. However, the load will not be protected from mains voltage sags, swells or

blackouts. The EU is removed for service when the UPS is operating in bypass. See

the Operation section of this manual for more details on this mode of operation.

Emergency Power Off jack

For applications where, for safety reasons, power to all room equipment must be cut

off, the UPS provides a remote Emergency Power Off interface. A modular 6 position

plug with offset latch fits this jack. See the Installation section of this manual for

instructions on how to connect to the jack.

3.0 Presentation

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 59 60

No comments

APC MXA002 Datasheet Page 14