APC Smart-UPS Specifications download pdf (Page 8)

Smart-UPS X-Series Operation4

Operation

Connect Equipment to the UPS

Note: The UPS will charge to 90% capacity in the first three hours of normal operation. Do

not expect full battery runtime capability during this initial charge period.

1. Connect equipment to the outlets on the rear panel of the UPS.

2. Connect the UPS to the building utility power. Connect the UPS to a two-pole, three-wire,

grounded source only.

3. Press the

ON/OFF button on the front panel of the UPS to power the unit and all connected

equipment.

4. To use the UPS as a master on/off switch, turn on all the equipment that is connected to the UPS.

See “Controllable Outlet Groups” on page 10 for information on how to use the Controllable

Outlet Groups.

Basic Connections

Serial port: Connect to a computer to use power management software.

USB port: Connect to a computer to use power management software.

External Battery Pack connector: Connect external battery packs to provide

extended runtime during power outages. The UPS can support up to five external

battery packs.

su0439a

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 27 28

No comments

APC Smart-UPS Specifications Page 8