APC InfraStruXure PDU Specifications download pdf (Page 50)

42 40kW InfraStruXure PDU—Operation and Configuration

Configuring the InfraStruXure Manager

Connect the PDU to the InfraStruXure Manager

1. Connect a Cat-5 network cable to the ethernet port on the PDU user connection plate.

You can make connections from

inside the enclosure, or you can

remove the user connection plate

and make your connections.

Remove the plate using a Phillips

or standard screwdriver to loosen

the two captive screws. Use the

knockout in the plate to route

cables to and from the user

connections on the plate. If you

remove the plate, make sure that

you do not disturb the existing connections.

2. Run the connected Cat-5 network cable through the knockout in the user connection plate to the

InfraStruXure Manager Hub.

3. Once all APC InfraStruXure-Certified equipment is installed, the network cables are connected

to the InfraStruXure Manager Hub, and start-up of the system is complete, configure the

InfraStruXure Manager.

See als

For detailed configuration instructions, see the InfraStruXure Manager Installation and

Quick-Start manual included with your InfraStruXure Manager.

1 2 ... 45 46 47 48 49 50 51 52 53 54 55 ... 87 88

No comments

APC InfraStruXure PDU Specifications Page 50