APC ACFS76080 Installation Manual download pdf (Page 85)

100

83Uniflair LE Accessories Manual

Using the touchscreen

Path: Main > Configuration > Unit > Communication

1. Turn on the power to the unit and wait for the touchscreen to display.

NOTE: Settings may appear on a different screen.

2. Enter your credentials and begin configuration.

BMS1 Serial Address: 001

BMS1 Serial Speed: 4800

BMS1 Serial Protocol: Standard

Remote ON/OFF Only Through Serial Communication: Enable

3. Press the Home button to return to the main screen.

LON serial card LED light functionality

The LonWorks network setup must follow LonWorks instructions and specifications. For further information on

installation, maintenance, cross-section, and cabling, refer to the LonWorks documentation.

RS485

pCOnet PCO1000BA0 (ACAC76123)

Electrical damage on the electronic components usually occurs because of electrostatic discharges caused by

improper handling by the operator. When handling these components, take the following precautions:

• Before handling any electronic component or card, ground the card.

• Keep the components inside their original package as long as possible. If necessary, take the main

board from a package and put it into an anti-static package without touching both sides of the board with

your hands.

• Avoid plastic bags and polystyrene.

• Avoid handing a card from one operator to another, to avoid any electrostatic induction and discharges.

The pCOnet board interfaces to pCO and connects to the BACnet MS/TP network (Master-Slave Token/Pass).

Condition Description

Green during the normal status of

LonWorks node

Signals the status of the LonWorks node, as per the LonWorks

protocol.

Green when activating the service

Remains on during the activation of the service pin.

Green when receiving the WINK

command

Remains on for a second when receiving a WINK command

from the network.

Red when signaling the failure of

the connection on the pCO side

If the red anomaly LED is not illuminated, check to ensure the

baud rate of the serial communication on pCO is set to 4800.

DANGER

HAZARD OF ELECTRIC SHOCK, EXPLOSION, OR ARC FLASH

Turn off all power supplying this equipment before working on the equipment. All electrical

work must be performed by licensed electricians. Practice Lockout/Tagout procedures.

Do not wear jewelry when working with electrical equipment.

Failure to follow these instructions will result in death or serious injury.

1 2 ... 80 81 82 83 84 85 86 87 88 89 90 ... 99 100

Comments to this Manuals

No comments

APC ACFS76080 Installation Manual Page 85

Comments to this Manuals

Related products and manuals for Hardware cooling accessories APC ACFS76080