APC P D U User's Guide download pdf (Page 98)

USER’S GUIDE

Switched Rack PDU

Use the Wizard

Launch the Wizard

The installation creates a shortcut link in the Start menu to launch the Wizard.

Configure the basic TCP/IP settings remotely

Prepare to configure the settings. Before you run the Wizard:

1. Contact your network administrator to obtain valid TCP/IP settings.

2. If you are configuring multiple unconfigured Network Management Cards or

network-enabled devices, obtain the MAC address of each one to identify it when

the Wizard discovers it. (The Wizard displays the MAC address on the screen on

which you then enter the TCP/IP settings.)

– For a Network Management Card that you install, the MAC address is on a label

on the bottom of the card.

– For a network-enabled device (with an embedded Network Management Card),

the MAC address is on a label on the device.

You can also obtain the MAC address from the Quality Assurance slip that came

with the Network Management Card or device.

Run the Wizard to perform the configuration. To discover and configure

unconfigured Network Management Cards or network-enabled devices over the

network:

1. From the Start menu, launch the Wizard. The Wizard detects the first Network

Management Card or network-enabled device that is not configured.

2. Select Remotely (over the network), and click Next >.

3. Enter the system IP, subnet mask, and default gateway for the Network

Management Card or device identified by the MAC address. Click Next >.

Most software firewalls must be temporarily disabled for the Wizard to

discover unconfigured Rack PDUs.

1 2 ... 93 94 95 96 97 98 99 100 101 102 103 ... 124 125

No comments

APC P D U User's Guide Page 98