APC NBRK0320E Datasheet download pdf (Page 83)

Advanced View: Configuring Pods and Alerts

74 Using Your Appliance

The Motion Mask Tab

The following controls are available on the Motion Mask tab:

Use the Motion Sensitivity Mask to configure your Camera Motion sensor to ignore movement that is

detected in specified regions of the image capture. To mask a portion of the image, click and drag in the

image to draw a box around the region you want to ignore. Then click Mask Selection to mask the

selected region. Red X’s will appear in the region of the image in which movement will be ignored.

To unmask a portion of a previously masked region, click and drag in the image to draw a box around the

region you want to unmask. Then, click Unmask Selection to remove the mask from the selected region.

Any red X’s that were displayed in the selected region will then be removed.

Type the new values in the appropriate fields. When you are finished, click OK and any changes you

have made will be saved to the appliance. Click Cancel to close the Camera Motion Configuration

window without saving any changes.

The Block Out Mask Tab

The following controls are available on the Block Out Mask tab:

Use the Block Out Mask to configure your camera so that specified areas of the image cannot be seen.

For example, you could place a Block Out Mask over the area of the image that shows a monitor image,

thereby preventing users from seeing the information that is shown on the monitor. Instead, a gray box

will appear in the masked area.

Field Description

Sensitivity The Sensitivity setting specifies how much change in a portion

of the image capture will be tolerated before the changed image

data is considered movement. Lower values indicate less

tolerance for change between images and therefore higher

sensitivity.

Area of Motion The Area of Motion setting specifies how large an area of the

image capture must change (as determined by the Sensitivity

value) before the changed image data is considered movement.

Lower Area of Motion values indicate smaller areas and

therefore higher sensitivity.

Enable Camera Motion check box Check this check box to enable the camera motion sensor.

Show outline of detected motion

check box

When this option is enabled, any region of an image captured

by the appliance that is determined to be indicative of motion is

surrounded by a dotted-line outline. Note that if this option is

enabled then the dotted-line outline will appear in the camera

image that is displayed in the Sensor Pane as well.

Motion Sensitivity Mask Use the Motion Sensitivity Mask to specify regions of the

image that will be ignored by the Camera Motion sensor.

Field Description

Enable Block Out Mask check box Check this check box to enable the Block Out Mask

functionality.

Block Out Mask Use the Block Out Mask to specify regions of the image that

will not be visible when the camera image is viewed.

1 2 ... 78 79 80 81 82 83 84 85 86 87 88 ... 209 210

Comments to this Manuals

No comments

APC NBRK0320E Datasheet Page 83

Comments to this Manuals

Related products and manuals for Racks APC NBRK0320E