APC Smart-UPS VT Installation Manual download pdf (Page 15)

Shipping, Receiving, and Unloading

Smart-UPS

VT Maintenance Bypass Panel w Power Distribution, 10-30kVA, 208V - 990-4199B 9

2. Record any damages observed and call the carrier immediately to allow their personnel to

conduct an equipment inspection, if necessary.

– Do NOT contact APC first—notify the carrier instead. Otherwise, APC may be unable to

assist in recovering the realized amount of the claim.

– All damage claims should be as specific as possible. Information pertaining to the shipment

should appear on the shipping label and related paperwork.

– BE SURE to request a copy of the carrier’s inspection report.

Unloading

1. Use a forklift or pallet-jack to transport the MBP to the installation site. Make certain the route

to the installation site can accommodate the size and weight of the unit (plus the lifting device).

2. At the installation site, remove a) the packaging material, b) the wooden ramp, and c) the plastic

sleeve (located inside the unit) containing the door keys and documentation. Also detach the

13/14mm wrench from the shipping pallet.

3. Use the 13/14mm wrench to remove the M8 bolt, and an M10 nut driver to remove the M6 bolt

from each of the four (4) angle brackets securing the MBP to its pallet.

Caution

Be aware that the MBP is shipped on its casters and may begin to roll once the bolts

have been removed. Take steps to prevent this from happening.

M8 Bolt

Angle Bracket

M6 Bolt

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 43 44

No comments

APC Smart-UPS VT Installation Manual Page 15