®
®®
®
USER’S GUIDE
network management card
14
Local access to the control console
You can use a local computer, a computer that connects to the
Management Card through the serial port at the Management Card’s UPS
or expansion chassis, to access the control console.
1. Select a serial port at the local computer and disable any service which
uses that port.
2. Unless an APC smart-signaling cable (940-0024 or 940-1524) is
already connected to the selected port, connect the smart-signaling
cable that came with the Management Card to the selected port and to
the serial port at the Management Card’s UPS or chassis.
3. Run a terminal program (such as HyperTerminal) and configure the
selected port for 2400 bps, 8 data bits, no parity, 1 stop bit, and no flow
control, and save the changes.
4. Press
ENTER to display the User Name prompt.
5. Enter your User Name and Password.
Comments to this Manuals