APC Network Management Card AP9617 User's Guide download pdf (Page 53)

®®

USER’S GUIDE

network management card

Syslog

By default, the Management Card can send messages to up to four Syslog

servers whenever Management Card, environmental monitor, or UPS

events occur. The Syslog servers, which must be specifically identified by

their IP address, record the events in a log that provides a centralized

record of events that occur at network devices.

Syslog settings. With the exception of the Server IP settings, the Syslog

settings should remain set to their defaults unless otherwise specified by

the Syslog network or system administrator.

This user’s guide does not describe Syslog, or the Syslog

configuration values, in detail. For more information about

Syslog, see RFC3164, a copy of which is available at

www.ietf.org/rfc/rfc3164.

General Settings

Setting Definition

Access (Web)

Syslog (CC)

Enables (by default) or disables the Syslog feature.

Facility

Selects the facility code assigned to the Management Card’s Syslog

messages (User, by default).

Note: Although several daemon-specific and process-specific

selections are available, along with eight generic selections,

User is the selection that best defines the Syslog messages sent

by a Management Card.

1 2 ... 48 49 50 51 52 53 54 55 56 57 58 ... 149 150

No comments

APC Network Management Card AP9617 User's Guide Page 53