APC 10-40kW 208/480V Installation Guide download pdf (Page 4)

4 Installation Guide Silcon DP300E 208V/480V 10-80 kVA

7OY0002 US rev. 04

Introduction – Unpacking

1.0 Introduction

The information given in this installation guide is of general nature for the local

authorized electrical installer. For the installation, please refer to national and

local electrical codes.

2.0 Unpacking

1. Unpack the system by removing the screws on the top and bottom part of the

packaging side plates and lift up the side plates as a whole.

2. Check that the type sign placed inside on the front door corresponds to the ordered

system, especially with respect to input / output voltages.

3. To simplify later identification of the installed system – please transfer the data

from the type sign to the below blank copy.

4. Transport the system to the installation site by lifting underneath by means of a

fork lift.

Copy of type sign (without battery):

Copy of type sign (with battery):

WARNING!

The UPS and related equip-

ment are very heavy. To prevent

personal injury or equipment

damage, use extreme care

when handling and transporting

the UPS cabinet and related

equipment.

WARNING!

Do never lift or transport the

system without the internal front

cover plate mounted and

fastened with screws.

1 2 3 4 5 6 7 8 9 ... 118 119

No comments

APC 10-40kW 208/480V Installation Guide Page 4