APC MGE 6739380EN/JC User Manual download pdf (Page 45)

6739380EN/JC - Page 45

Inverter On/Off commands

Display for the inverter On/Off commands

Direct access to the function by pressing

the "I/O" button .

This screen is displayed if the inverter is already

off. It is a prompt to press the "*" button to

confirm start-up. During start-up, the following

screen is displayed:

This screen is displayed if the inverter is on. It is

a prompt to press the "*" button to confirm

shutdown.

If the transfer to Mains 2 conditions are not

correct, the following screen is displayed a few

seconds:

Following confirmation of the command, the

system automatically returns to the initial

screen.

PROCESSING

…

COMMAND REFUSED

TRANSFER IMPOSSIBLE

Language, display contrast and buzzer volume settings

Direct access to the function by pressing the

"settings" button.

Selection of the display language: English,

French, German, Italian, Spanish, Dutch,

Swedish, Finnish, Portuguese.

This screen is a prompt to set the display

contrast by successively pressing the ">" button.

When the setting is confirmed by pressing the

"*" button, the system goes on to the buzzer.

When this screen is displayed, the buzzer

automatically turns on. Press the ">" button

several times to adjust the volume. After

confirmation of the buzzer volume by the "*"

button, the system automatically returns to the

initial screen.

Display of the settings selection screens

◗ if a "Soft Tunor" session is in

progress (initiated by after-sales

support technicians), pressing the "I/O"

button produces the message:

COMMAND INVALID

SOFT TUNOR

These commands may be accessed

only via the master display. When the

"I/O" button is pressed, the series of

screens in the figure opposite is

displayed.

Note:

◗ these commands do not concern the

Static Switch Cubicle. The "I/O" button

on the "static switch" cubicle produces

the message:

COMMAND INVALID

STATIC SWITCH MODUL

◗ the "I/O" button on a slave display

monitor produces the message:

COMMAND INVALID

ON SLAVE DISPLAY

◗ if the On/Off commands have not

been validated (by the after-sales

support technicians), pressing the "I/O"

button produces the message:

COMMAND INVALID

CONFIGURATION

These settings may be accessed by

pressing the "settings" button.

The series of screens in the figure

opposite is displayed.

*

*

START INVERTER ?

=YES >=ESCAPE

or

initial screen

initial screen

*

STOP INVERTER ?

=YES >=ESCAPE

*

LANGUAGE = ENGLISH

=CONFIRM.

initial screen

*

DISPLAY CONTRAST

>=SELECT =CONFIRM.

*

BUZZER VOLUME

>=SELECT =CONFIRM.

*

*

*

*

"Monitor" alphanumeric display (cont.)

1 2 ... 40 41 42 43 44 45 46 47 48 49 50

Comments to this Manuals

No comments