APC SU043 Datasheet download pdf (Page 17)

APC Redundant Switch: Installation and Operation Manual 13

Configuration

Supported

configurations

Two supported configurations for Redundant Switch are shown

below. For more information on these and other supported

configurations, visit the

APC

Web site at

www.apc.com

Configuring

PowerChute

plus

1. Install PowerChute

plus

as described in the enclosed

software installation instructions.

2. For Source B:

a. At the Redundant Switch front panel, set the Source

Preference to Source

b. Start the computer on which PowerChute

plus

installed.

c. Start PowerChute

plus

. Communication is to

UPS

d. Configure

UPS

according to your requirements.

e. Set the

UPSID

UPS_B

3. For Source A:

a. At the Redundant Switch front panel, set the Source

Preference to Source

Note

Install only

SNMP

accessories in the

UPS

. You

must install any other accessories in the

Redundant Switch

Both

UPS

s must be the same sine-wave model.

Minimum acceptable

configuration:

Redundant Switch

with two Smart-UPS units

connected to one

line (the same

facility power source).

Best configuration:

Redundant

Switch

with two Smart-UPS units

connected to two separate

lines

(each

UPS

receiving power from a

separate facility power source).

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 33 34

Comments to this Manuals

No comments

APC SU043 Datasheet Page 17

Comments to this Manuals

Related products and manuals for Power distribution units (PDUs) APC SU043