APC MGE Galaxy 300 User's Guide download pdf (Page 50)

UPS Network Management Card 2 User’s Guide41

Output Relay Page

This option is only available for devices with installed Dry Contact I/O Accessories. Select the

Environment tab, then Universal I/O from the top menu bar. Click Output Relay to display the status of

the output relay and configure its values.

About Page

Click About on the left navigation menu of the top menu bar option Environment to display what

environmental monitoring devices are in use with this UPS and their firmware versions.

Parameter Description

Name A name for this output relay. Maximum: 20 characters.

Location The location of this output relay. Maximum: 20 characters.

Alarm Status Normal if this output relay is not reporting an alarm, or the severity of the alarm if this

output relay is reporting an alarm.

State The current state of this output relay: Closed or Open.

Normal State The normal (non-alarm) state of this output relay: Closed or Open.

Control To change the current state of this output relay, check-mark the setting.

Delay The number of seconds a selected alarm condition must exist before the output relay is

activated. Use this setting to avoid activating an alarm for brief transient conditions.

NOTE: Even if additional mapped alarms occur after the delay begins, the delay does not

restart but continues until the output relay is activated.

Hold The minimum number of seconds the output relay remains activated after the alarm occurs.

Even if the activating alarm condition is corrected, the output relay remains activated until

this time period expires.

1 2 ... 45 46 47 48 49 50 51 52 53 54 55 ... 104 105

No comments

APC MGE Galaxy 300 User's Guide Page 50