APC MGE Galaxy 300 User's Guide download pdf (Page 35)

26Network Management Card User’s Guide

user

Access: Administrator only

Description: Configure the user name and password for each account type, and configure the inactivity

timeout.

For information on the permissions granted to each account type (Administrator, Device

User, and Read-Only User), see “Types of user accounts” on page 3.

Example: To change the Administrator user name to XYZ, type:

user -an XYZ

To change the Administrator password to XYZ, type:

user -ap XYZ

-output <phase#> | all Display the output measurements for the chosen phase of the UPS.

Typing “all” displays the information for all phases of the UPS.

voltage | current | load |

power | percload | pf |

frequency | all

Specify the output measurement for the ups command.

Example: ups -output 2 percload

Displays the percentage of load for phase 2 of the UPS.

-batt Display the battery status of the UPS

-about Displays information about the UPS.

-al <c | w> Display all existing alarms. Specifying “c” or “w” limits the display to

either Critical (c) or Warning (w) alarms.

Option Argument Description

-an

-dn

-rn

<read-only name>

Set the case-sensitive user name for each account type. The maximum

length is 10 characters.

-ap

-dp

-rp

<read-only password>

Set the case-sensitive password for each account type. The maximum

length is 32 characters. Blank passwords (passwords with no

characters) are not allowed.

-t <minutes> Configure the time (3 minutes by default) that the system waits before

logging off an inactive user.

Option Argument Description

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 104 105

No comments

APC MGE Galaxy 300 User's Guide Page 35