APC MGE Galaxy 300 User's Guide download pdf (Page 79)

70Network Management Card User’s Guide

To. Select the IP address or host name to which a test SNMP trap will be sent. If no trap receiver is

configured, a link to the Trap Receiver configuration page is displayed.

Remote Monitoring Service

Path: Administration > Notification > Remote Monitoring

The Remote Monitoring Service (RMS) is an optional service that monitors your system from a remote

operation center 24 hours a day, 7 days a week, and notifies you of device and system events.

To purchase the RMS service, contact your American Power Conversion vendor or see the

RMS Web site, rms.apc.com.

Registration. To activate RMS for the Management Card, select Enable APC Remote Monitoring

Service., choose between Register Company and Device and Register Device Only, complete the

form, and click Send APC RMS Registration.

Use the Reset APC Remote Monitoring Service Registration check box to discontinue the service,

whether permanently or temporarily (for example, if you are moving a Management Card).

Syslog

Path: Logs > Syslog > options

The Management Card can send messages to up to four Syslog servers when an event occurs. The Syslog

servers record events that occur at network devices in a log that provides a centralized record of events.

This user’s guide does not describe Syslog or its configuration values in detail. See RFC3164

for more information about Syslog.

Identifying Syslog Servers.

Path: Logs > Syslog > servers

Setting Definition

Syslog Server Uses IPv4/ IPv6 addresses or host names to identify from one to four servers to receive

Syslog messages sent by the Management Card.

Port The user datagram protocol (UDP) port that the Management Card will use to send Syslog

messages. The default is 514, the UDP port assigned to Syslog.

Protocol Choose between UDP and TCP.

Language Choose the language for any Syslog messages.

1 2 ... 74 75 76 77 78 79 80 81 82 83 84 ... 104 105

No comments

APC MGE Galaxy 300 User's Guide Page 79