APC Smart-UPS VT Installation Manual download pdf (Page 26)

Installation

20 Smart-UPS

VT Maintenance Bypass Panel w Power Distribution, 10-30kVA, 208V - 990-4199B

10. Insert the six (6) previously removed M6 bolts through the designated assembly holes (see

graphic) in the MBP, the baying adapter, and the UPS. Attach an M6 flange nut to the other end

of each bolt. Use an M10 nut driver with an appropriate size wrench and bind until rigid.

11. Attach the side panel that was previously removed from the UPS to the open side of the MBP.

The side panel is attached by sliding it down into the grooves at the base of the MBP.

12. Re-attach the top cover to the MBP. Place the top cover onto the MBP enclosure, and then use a

Phillips screwdriver to tighten the four (4) M4 Phillips screws. Refer to Step 5 graphic.

Note

The following steps in this process (#11 and #12) can either take place now or after

making the electrical connections.

MBP

Baying Adapter

UPS

(front)

Baying Adapter

(rear)

M6 Bolts (3)

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 43 44

No comments

APC Smart-UPS VT Installation Manual Page 26