APC MGETM GALAXYTM 6000 User Manual download pdf (Page 30)

Page 30 - 6739381EN/JD

Fig. 22

Connection of "Media Contacts 15" additional auxiliary circuits (option) (figure 22)

The additional auxiliary circuits of the

rectifier-inverter and Static Switch

Cubicles are connected to additional

remote relay board by means of the 4

connectors (see location of this board

in the figures of the "connection of

power circuits" section).

◗ recommended cable cross-section:

1 mm

;

◗ the male connectors that fit the

female connectors on the board

(XR5 to XR9) are supplied;

◗ the contacts are volt-free and are

shown in the diagram under the following

conditions: UPS on, contact at rest;

ACPZ board of the Static Switch Cubicle

◗ contact breaking capacity: 250V, 5A.

Note:

In a parallel-connected UPS installation

the "load" and "mains 2" signals are

provided by the Static Switch Cubicle.

XR7

additional remote

relay board

connector XR5

(option)

output signals:

connector XR6

(option)

connector XR8

(option)

input signals:

connector XR7

(option)

XR8

XR9

XR6

XR5

connector XR9

(option)

overload (2)

inverter function fault (1)

overload (2)

inverter function fault (1)

rectifier-charger operating (1)

rectifier-charger function fault (1)

rectifier-charger operating (1)

rectifier-charger function fault (1)

transfer to Mains 2 inhibited (3)

transfer function fault (2)

transfer to Mains 2 inhibited (3)

transfer function fault (2)

transfer to Mains 2 inhibited (4) (5)

desynchronization with Mains 2 (3)

transfer to Mains 2 with interruption inhibited (4) (5)

battery charge current limiting (1)

gradual rectifier-charger shutdown (1)

current limiting on generator power (1)

remote inverter on (1)

auxiliary signal (2)

remote inverter off (1)

(1) for:

◗

single-unit UPS cubicle,

◗

modular UPS cubicle,

◗

parallel UPS cubicle with SSC.

(2) for:

◗

single-unit UPS cubicle,

◗

modular UPS cubicle,

◗

parallel UPS cubicle with SSC,

◗

Static Switch cubicle.

(3) for:

◗

single-unit UPS cubicle,

◗

modular UPS cubicle,

◗

Static Switch cubicle.

(4) in modular UPSs, these functions are

available via the "auxiliary information" contact

(connector XR9, terminals 7-8).

(5) for:

◗

single-unit UPS cubicle,

◗

Static Switch cubicle.

Installation (cont.)

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 45 46

Comments to this Manuals

No comments

APC MGETM GALAXYTM 6000 User Manual Page 30

Comments to this Manuals

Related products and manuals for UPS batteries APC MGETM GALAXYTM 6000