APC MGETM GALAXYTM 6000 User Manual download pdf (Page 32)

Page 32 - 6739381EN/JD

QF1

self-adhesive

"on" light

mounting

brackets

tie the

cable

to the

cubicle

upright

tie the cable

to the cubicle

upright

to rectifier-inverter

battery cubicle

"Temperature Monitor"

installation in a APC by

Schneider Electric battery

cubicle

The "Temperature Monitor" is fitted on

mounting brackets inside the left-hand

door of the battery cubicle containing

circuit breaker QF1 (see figure 25).

The unit is self-adhesive and is secured

simply by pressing it against the door:

◗ before mounting the unit, break the

knock-out in its base plate provided for

feeding through the connecting cable;

◗ clean the mounting location on the

door using isopropyl alcohol or heptane

to obtain a clean, dry adhesion surface

(comply with supplier safety

recommendations for handling

solvents);

◗ it is essential, for correct temperature

sensor operation, for the unit to be

positioned as shown in figure 25 ("on"

light in the top left hand corner and

cable fed through from the right-hand

side);

◗ firm pressure is required to ensure

that the unit is bonded over the full

adhesive surface;

◗ the door should be at a temperature

of at least 10°C;

◗ after installation, fold up the

mounting bracket tabs to fully secure

the unit;

◗ tie the connecting cable to the

cubicle upright so that it does not pull

on the unit.

Installing the "Temperature Monitor" in a battery cubicle

Fig. 25

"Temperature Monitor"

installation in a battery room

The "Temperature Monitor" should be

secured against a wall or any vertical

support:

◗ choose a location near the batteries

and away from draughts which

adversely affect the accuracy of

temperature measurements;

◗ position the unit correctly ("on" light

in the top left hand corner and cable fed

through from the right-hand side);

◗ use the holes provided in the base

plate to screw the unit to the vertical

support (see figure 26);

◗ unless the connecting cable runs on

the surface, break the knock-out in the

unit base plate provided for cable entry;

◗ secure the cable by suitable means

so that it does not pull on the unit.

"Temperature Monitor" base

Fig. 26

oblong holes

for fastening screws

knock-out for

lateral cable

entry

oblong holes

for fastening screws

board

dimensions of the "Temperature Monitor": 75 x 75 x 21 mm

Installation (cont.)

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 45 46

Comments to this Manuals

No comments

APC MGETM GALAXYTM 6000 User Manual Page 32

Comments to this Manuals

Related products and manuals for UPS batteries APC MGETM GALAXYTM 6000