APC AP9224 Datasheet download pdf (Page 12)

MasterSwitch VM: Installation and Quick-Start Manual 9

Installing MasterSwitch VM

b. Flat bracket, for a two-post rack. Using this bracket

may require you to drill holes in the rack.

2. Choose a suitable location for the unit. The following

example figure shows an

AP9227 or AP9228 model

mounted in four different locations in the enclosure.

The mounting procedure will vary according to the

location you choose. To avoid interfering with shelves or

equipment, install the unit so that it hangs on the outside

edge of the vertical rail, as shown in the figure. Installing

the unit may take some adjusting, depending on where

you want to install it:

– To install any MasterSwitch VM unit in the rear of the

enclosure: Adjust the back rail to allow room for the

rear door to close. If necessary, adjust the front rail too.

– To install an AP9227 or AP9228 MasterSwitch VM

unit on the side of the enclosure: Move the horizontal

cross members to the highest and lowest positions on

the vertical mounting rails.

– To install an AP9227 or AP9228 MasterSwitch VM

unit into an expansion enclosure: Move the baying

brackets from the highest and lowest positions on the

rail (if they have not been moved since shipping) and

then move the horizontal cross members to the highest

and lowest positions on the vertical rails.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 31 32

No comments

APC AP9224 Datasheet Page 12