MasterSwitch VM: Installation and Quick Start Manual 21
Quick Configuration for Controller-based Systems
Required
configuration
You must configure the network settings of MasterSwitch VM
before it can operate on a network. The required settings for
are:
• IP address of MasterSwitch VM
• Subnet Mask
• IP address of the default Gateway
After you have configured MasterSwitch VM network settings,
no further configuration is required.
Configuring
TCP/IP settings
Choose the configuration method that matches your
environment.
• If you are using Windows™ 95,Windows 98, Windows
NT, or Windows 2000, see “Through the Management
Card Wizard” on page 22.
• If you are not using Windows or require direct serial
configuration, see “Serially through the Control
Console” on page 22.
• If you are a network administrator using BOOTP, see
“Over the Network by BOOTP” on page 23.
• If you are a network administrator and have access to a
computer connected to the local subnet, see “Over the
Network by ARP” on page 24.
ee a
so
The remaining MasterSwitch VM properties are
pre-configured at the factory. However, these
properties may not be appropriate for your
application. See “Management” in the
MasterSwitch VM User’s Manual (usrguide.pdf)
on the CD.
Comments to this Manuals