93Uniflair LE Accessories Manual
Installation
1. Disconnect the power.
2. Using a screwdriver, remove the plastic hatch from the electronic controller.
3. If necessary, select the type of analog inputs using the dip switch. This must be done before installing
the card (pCO
1
controller only).
4. Using a cutting nippers, remove the precut plastic hatch.
5. Insert the card in the corresponding plug-in connector, making sure it is fully inserted against the two
plastic supports on the pCO
controller.
6. Close the cover, ensuring the connector on the optional card lines up with the cover.
The modem is connected using the 9-pin socket on the card. A diagram of the pins on the connector are shown
in the following figure.
Socket Description Socket Description
n.c GND Frame
RX n.c
TX RTS
DTR n.c
na4767a
Comments to this Manuals