APC AP7602 Instruction Manual download pdf (Page 133)

Mass Configuration: Sensor and Alert Settings

132 InfraStruXure Central 4.0 User’s Reference

To define a maximum value threshold:

1. Launch the Sensor & Alert Settings task that corresponds to the numeric-based sensor for which

you will define a threshold.

2. Select Maximum Value Threshold from the Threshold drop box. Any selected devices that have

previously defined maximum value thresholds will be listed in the Management Devices list.

3. Select the desired threshold operation and targets:

– If you are editing one or more previously defined maximum value thresholds, select the devices

on which the threshold has been configured from the Management Devices list and then click

Edit.

– If you are defining a new maximum threshold click Add. Then, select one or more devices for

which this threshold will be configured, and click Next. Finally, select the sensors on the selected

devices for which this threshold will be configured and then click Next.

4. Type in the Threshold Name field a name for this threshold.

5. Specify Basic threshold settings. From the Basic tab in the Thresholds pane:

a. Type in the Maximum field (or use the arrows in the field to specify) the highest acceptable value

for the selected sensors. This is the value that, if exceeded, will result in an alert condition.

b. Check the Enabled check box to enable the threshold. If this check box is not checked, the alert

threshold will be saved but will not be active.

Add to the Threshold-Specific Addresses list the e-mail addresses of any personnel to whom e-

mail alert notifications should be sent if this threshold triggers an alert condition. Click Add...,

type in the e-mail address to which the alert notification will be sent, and then click OK.

If you’ve installed an SMS-capable modem you can deliver alert notification to SMS-enabled

devices by entering threshold-specific addresses for them in the following format:

sms:sms_device_address

where sms_device_address is the telephone number or e-mail address associated with the SMS-

enabled device (for example, “sms:5123334444” or “sms:[email protected]”).

6. If desired, specify Advanced Threshold settings. All Advanced threshold settings are optional. From

the Advanced tab in the Thresholds pane:

– Specify a Return To Normal Delay value. Use the controls to specify the number of seconds that

must pass after this threshold has returned to normal before the threshold state is considered

returned to normal. Default value is 0 (state returns to normal immediately after the measured

value is no longer violating the threshold).

– Set an Advanced Schedule for this threshold (optional). By default, all thresholds are assumed to

be enabled 24 hours a day, 7 days a week. However, you can specify that a threshold will be

enabled only during specific time ranges. To set an Advanced Schedule:

a.Click Advanced Schedule.... The Schedule Threshold window opens.

Note

These threshold-specific notifications are sent only if your device has one or more Alert

Actions defined that use the Send E-Mail Message alert notification method and that have

the Include Addresses from Thresholds check box checked. For more information, see

“Alert Actions” on page 113 and “Creating Alert Actions” on page 221.

1 2 ... 128 129 130 131 132 133 134 135 136 137 138 ... 293 294

Comments to this Manuals

No comments

APC AP7602 Instruction Manual Page 133

Comments to this Manuals

Related products and manuals for Power supply units APC AP7602