APC AP7602 Instruction Manual download pdf (Page 142)

Mass Configuration: Sensor and Alert Settings

InfraStruXure Central 4.0 User’s Reference 141

list.

3. Select the desired threshold operation and targets:

– If you are editing one or more previously defined below value for time thresholds, select the

devices on which the threshold has been configured from the Management Devices list and then

click Edit.

– If you are defining a new below value for time threshold click Add. Then, select one or more

devices for which this threshold will be configured, and click Next. Finally, select the sensors on

the selected devices for which this threshold will be configured and then click Next.

4. Type in the Threshold Name field a name for this threshold.

5. Specify Basic threshold settings. From the Basic tab in the Thresholds pane:

a. Type in the Minimum field (or use the arrows in the field to specify) the highest acceptable value

for the selected sensors. This is the value that, if fallen below for greater than the number of

seconds specified in the Time Allowed Below Minimum field, will result in an alert condition.

b. Type in the Time Allowed Below Minimum field (or use the arrows in the field to specify) the

number of seconds that the reported value can fall below the value specified in the Minimum

field before an alert condition is generated.

c. Check the Enabled check box to enable the threshold. If this check box is not checked, the alert

threshold will be saved but will not be active.

Add to the Threshold-Specific Addresses list the e-mail addresses of any personnel to whom e-

mail alert notifications should be sent if this threshold triggers an alert condition. Click Add...,

type in the e-mail address to which the alert notification will be sent, and then click OK.

If you’ve installed an SMS-capable modem you can deliver alert notification to SMS-enabled

devices by entering threshold-specific addresses for them in the following format:

sms:sms_device_address

where sms_device_address is the telephone number or e-mail address associated with the SMS-

enabled device (for example, “sms:5123334444” or “sms:[email protected]”).

6. If desired, specify Advanced Threshold settings. All Advanced threshold settings are optional. From

the Advanced tab in the Thresholds pane:

– Specify a Return To Normal Delay value. Use the controls to specify the number of seconds that

must pass after this threshold has returned to normal before the threshold state is considered

returned to normal. Default value is 0 (state returns to normal immediately after the measured

value is no longer violating the threshold).

– Set an Advanced Schedule for this threshold (optional). By default, all thresholds are assumed to

be enabled 24 hours a day, 7 days a week. However, you can specify that a threshold will be

enabled only during specific time ranges. To set an Advanced Schedule:

a.Click Advanced Schedule.... The Schedule Threshold window opens.

b.By default, all time periods in the schedule are set to Enabled. To disable the threshold for a

currently enabled period of time, highlight the period of time by clicking-and-dragging over the

Note

These threshold-specific notifications are sent only if your device has one or more Alert

Actions defined that use the Send E-Mail Message alert notification method and that have

the Include Addresses from Thresholds check box checked. For more information, see

“Alert Actions” on page 113 and “Creating Alert Actions” on page 221.

1 2 ... 137 138 139 140 141 142 143 144 145 146 147 ... 293 294

Comments to this Manuals

No comments

APC AP7602 Instruction Manual Page 142

Comments to this Manuals

Related products and manuals for Power supply units APC AP7602