APC AP7602 Instruction Manual download pdf (Page 165)

Mass Configuration: Device Settings

164 InfraStruXure Central 4.0 User’s Reference

Use the Motion Sensitivity Mask to configure the Camera Motion sensor to ignore movement that is

detected in specified regions of the image capture. To mask a portion of the image, click and drag in the

image to draw a box around the region you want to ignore. Then click Mask Selection to mask the

selected region. Red X’s will appear in the region of the image in which movement will be ignored.

To unmask a portion of a previously masked region, click and drag in the image to draw a box around the

region you want to unmask. Then, click Unmask Selection to remove the mask from the selected region.

Any red X’s that were displayed in the selected region will then be removed.

When you are finished, click OK and any changes you have made will be saved to the selected devices.

Click Cancel to close the Camera Masking task without saving any changes.

The Block Out Mask Tab

The following controls are available on the Block Out Mask tab:

Use the Block Out Mask to configure the cameras of selected devices so that specified areas of the image

cannot be seen. For example, you could place a Block Out Mask over the area of the image that shows a

monitor image, thereby preventing users from seeing the information that is shown on the monitor.

Instead, a gray box will appear in the masked area.

To mask a portion of the image, click and drag in the image to draw a box around the region you want to

ignore. Then right-click and select Mask Selection to mask the selected region. A blue block will appear

in the region of the image to be blocked.

To unmask a portion of a previously masked region, click and drag in the image to draw a box around the

region you want to unmask. Then, click Unmask Selection to remove the mask from the selected region.

Any portion of the blue block out mask that you selected will then be removed.

When you are finished, click OK and any changes you have made will be saved to the device. Click

Cancel to close the Camera Masking task without saving any changes.

Show outline of detected motion

check box

When this option is enabled, any region of an image captured by

the device that is determined to be indicative of motion is

surrounded by a dotted-line outline. Note that if this option is

enabled then the dotted-line outline will appear in the camera

image that is displayed in the Sensor Pane as well.

Motion Sensitivity Mask Use the Motion Sensitivity Mask to specify regions of the image

that will be ignored by the Camera Motion sensor.

Field Description

Enable Block Out Mask check box Check this check box to enable the Block Out Mask

functionality.

Block Out Mask Use the Block Out Mask to specify regions of the image that will

not be visible when the camera image is viewed.

1 2 ... 160 161 162 163 164 165 166 167 168 169 170 ... 293 294

No comments

APC AP7602 Instruction Manual Page 165