APC AP7602 Instruction Manual download pdf (Page 286)

Troubleshooting

InfraStruXure Central 4.0 User’s Reference 285

where <directory-name> is the Directory on Server value (including macros) as defined in your FTP

Data Delivery settings and then press Enter.

5. If this fails (with a message starting with a number other than 2xx), attempt to create the directory

by using the MKDIR command and the <directory name> string. Type at the prompt

MKDIR <directory-name>

where <directory-name> is the Directory on Server value (including macros) as defined in your FTP

Data Delivery settings and then press Enter. If the MKDIR fails (with a message starting with a

number other than 2xx), the server is either not accepting the provided directory name (possibly due

to a length limitation, filename format limitation (such as no embedded spaces, more than one

decimal point), or an access restriction on the user's account).

6. If the MKDIR succeeds (with a message starting with 2xx), enter the CD command again. If the CD

command fails again (with a message starting with a number other than 2xx), the server may not

support the file name format, or be configured to allow the user to enter the directory.

7. Repeat step 4 through 6 for each directory in the directory path.

8. Enter the command ASCII. The resulting message should start with a number 2xx. If not, the FTP

server is non-standard.

9. Use the PUT command to send a text file to the base filename configured for the FTP data delivery

(with macros substituted as noted above) and with “.nbsensor” concatenated on the end. Type at the

command prompt

PUT <some-file> <base-filename>.nbsensor

If this does not succeed (with a message starting with 2xx), the user account may not have sufficient

access to write or create files, the server may not support the filename format, or the server may be

full.

10. Enter the command BINARY. The resulting message should start with a number 2xx. If not, the FTP

server is non-standard.

11. Use the PUT command to send a binary file, such as a JPG file, to the base filename configured for

the FTP data delivery (with macros substituted as noted above) and with “_01.jpg” concatenated on

the end:

PUT <some-file> <base-filename>_01.jpg

Note

If your directory name includes macros that are device specific and which do not change

(such as ${IP}, ${SERIAL}, or ${MODEL}) and you know the appropriate macro value

then use that value as part of the CD command. Otherwise, use the example value string

provided in the table above.

For example, if the Directory on Server field in the FTP Data Deliveries settings has the

default macros only (${SERIAL}/${DATE}) and you know the serial number of your

device is “00_02_D3_D1_02_00” but you choose to use the example data value (2001-11-

06) you would enter the following command at the prompt:

CD 00_02_D3_D1_02_00/2001-11-06

Finally, If the directory name contains any spaces, be sure enclose it in double-quotes (i.e.

CD “<directory name with spaces>”).

1 2 ... 281 282 283 284 285 286 287 288 289 290 291 292 293 294

Comments to this Manuals

No comments

APC AP7602 Instruction Manual Page 286

Comments to this Manuals

Related products and manuals for Power supply units APC AP7602