APC AP9212 Technical Information download pdf (Page 15)

Chapter 2:

How to Manage the SNMP Agent at a Hardware Device

PowerNet MIB Reference Guide

[mcontrol]

The following table describes the one OID in the [mcontrol] category. Value (3), not documented, is

obsolete.

[mconfig]

The following table describes the [mconfig] OIDs.

See How To Define Trap Receivers in Chapter 9, PowerNet MIB Traps for information on how to

define trap receivers.

OID Values You Can SET

mcontrolRestartAgent restartCurrentAgent (1): Reboots the SNMP Agent.

continueCurrentAgent (2): Continues the Agent without rebooting.

restartWithoutAgent (4): Restarts the system without starting the Agent.

The next time the system restarts, the Agent also restarts.

OID Task

mconfigBOOTPEnabled Identify the current BOOTP setting. A GET to this OID returns

one of the following:

• yes (1): Enable BOOTP. The hardware device will obtain its IP

configuration parameters from a BOOTP server.

• no (2): Disable BOOTP. The hardware device will use the IP

configuration parameters stored in its EPROM.

mconfigNumTrapReceivers Identify how many NMSs can receive traps from the Agent. A

GET to this OID returns a value from 0 to 4.

{mconfigTrapReceiverTable}

{mconfigTrapReceiverEntry}

trapIndex

receiverAddr

communityString

severity

acceptThisReceiver

receiveTrapType

Use this tabled set of OIDs to define up to four NMSs as trap

receivers. See How To Define Trap Receivers in Chapter 9,

PowerNet MIB Traps for information on the OIDs in this table.

mconfigClock Configure the date and time on a Web/SNMP Management Card,

Network Management Card, or MasterSwitch unit.

• mconfigClockDate in mm/dd/yyyy format

• mconfigClockTime in hh:mm:ss am/pm format

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 94 95

No comments

APC AP9212 Technical Information Page 15