APC AP9212 Technical Information download pdf (Page 84)

Chapter 9:

PowerNet MIB Trap Definitions

PowerNet MIB Reference Guide

returnFromBypass Informational 23: The Matrix-UPS returned from bypass mode.

bypassPowerSupplyFailure Severe 24: The Matrix-UPS base module bypass power

supply needs repair.

baseFanFailure Severe 25: The Matrix-UPS base module fan needs repair

batteryPackCommLost Severe 26: Communication with external battery packs

was lost (Matrix-UPS or Smart-UPS XL).

batteryPackCommEstablished Informational 27: Communication with external battery packs

was regained (Matrix-UPS or Smart-UPS XL).

calibrationStart Informational 28: A runtime calibration has started.

restartAgent Informational

29: The Management Card’s SNMP agent is

restarting as commanded by the NMS

upsTurnedOn Informational 30: The UPS is turned on.

smartTrimOn Warning 31: The UPS enabled its AVR Trim feature.

codeAuthenticationDone Informational 32: Authentication of TFTP agent file code image

is done.

upsOverloadCleared Informational 33: The UPS overload condition is corrected.

smartBoostOff Informational

34: The Smart-UPS returned from using its AVR

Boost feature.

smartAvrReducingOff Informational 35: The Matrix-UPS returned from using AVR

Trim feature.

upsBatteryReplaced Informational 36: Bad battery replaced.

calibrationEnd Informational 37: Runtime calibration ended.

dischargeCleared Informational 38: UPS discharge condition ended.

gracefullShutdown Informational 39: Graceful shutdown started.

Not currently used. none 40: No value.

outletOn Informational 41: The MasterSwitch outlet specified by

sPDUOutletControlIndex is turned on or, if

that value is 0, all outlets are turned on.

outletOff Informational 42: The MasterSwitch outlet specified by

sPDUOutletControlIndex is turned off or, if

that value is 0, all outlets are turned off.

outletReboot Informational 43: The MasterSwitch outlet specified by

sPDUOutletControlIndex was rebooted or, if

that value is 0, all outlets were rebooted.

configChange Warning 44: The MasterSwitch SNMP configuration

changed.

Trap Severity Number and Description (Sheet 2 of 9)

1 2 ... 79 80 81 82 83 84 85 86 87 88 89 ... 94 95

No comments

APC AP9212 Technical Information Page 84