APC AP9212 Technical Information download pdf (Page 27)

Chapter 3:

How to Configure a UPS

PowerNet MIB Reference Guide

How to Configure a UPS

You can use the OIDS in the [upsConfig] category to define how the UPS responds to specific

operating conditions.

[upsConfig]

Which [upsConfig] OIDs you can use depends on how the Management Card or PowerNet Agent

connects to the UPS. The [upsConfig] category has two subcategories:

• [upsBasicConfig] for simple-signalling connections, which provide basic power management

and protection but offer few additional configuration and monitoring options. (A Back-UPS

supports only simple-signalling.)

• [upsAdvConfig] for smart-signalling connections, which provide full support for the advanced

configuration and monitoring options available on all APC UPSs except Back-UPS.

[upsBasicConfig]

The [upsBasicConfig] category has one read-only OID and a tabled set of OIDs that you can use to

view or define information about the equipment supported by the UPS.

OID Task

upsBasicConfigNumDevices Identify the number of devices specified in the tabled set of

OIDS {upsBasicConfigDeviceTable}, i.e. the number of

devices plugged into the UPS.

{upsBasicConfigDeviceTable}

{upsBasicConfigDeviceEntry}

deviceIndex

deviceName

vaRating

acceptThisDevice

View or define information about the equipment supported

by each UPS outlet:

• View read-only value that identifies the specific outlet.

• Define a 16-character name for the device at this outlet.

• Define the VA rating of the device this outlet supports

Add a device entry to the table or delete and existing device

entry:

• yes (1): Add an entry.

• no (2): Delete an entry.

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 94 95

No comments

APC AP9212 Technical Information Page 27