APC AP9212 Technical Information download pdf (Page 46)

Chapter 5:

[sPDUMasterControl] Master Control OIDs

PowerNet MIB Reference Guide

[sPDUMasterControl] Master Control OIDs

The [sPDUMasterControl] category has two OIDs that respond to GETs with information about all eight outlets and a

third OID that uses SETs to directly affect the operation of all outlets simultaneously.

OID Task

sPDUMasterControlSwitch

Affect the operation of all outlets.

• turnAllOnNow (1): Immediately turn on all outlets.

• turnAllOnSequence (2): Turn on all outlets by using the

sPDUOutletPowerOnTime OID value for each outlet.

• turnAllOffNow (3): Immediately turn off all outlets.

• rebootAllNow (4): Immediately reboot all outlets by turning off power and then

turning on power based on the master power’s sPDUMasterConfigReboot

configuration OID value.

• rebootAllSequence (5):

- For firmware version 2.x: Turn off all outlets as described for

turnAllOffSequence, wait the delay time specified as

sPDUMasterConfigReboot, and then turn on all outlets as described for

turnAllOnSequence.

- For firmware version 1.x: Reboot all outlets as described for

turnAllOnSequence.

• noCommand (6): The value returned for a GET.

• turnAllOffSequence (7): Turn off all outlets by using each outlet’s

sPDUOutletPowerOffTime configuration OID value.

Note: The turnAllOffSequence (7) setting has no effect when used with

firmware version 1.x.

sPDUMasterState

Identify the on or off status of the eight outlets.

sPDUMasterPending

Identify whether any outlet has a command pending (yes or no).

For information on [sPDUMasterConfigReboot] and [sPDUMasterConfigPowerOn], see [sPDUMasterConfig] Master

Configuration OIDs; for information on [sPDUMasterConfigReboot] and [sPDUOutletPowerOnTime] OIDs, see

[sPDUOutletConfig] Outlet Configuration OIDs.

1 2 ... 41 42 43 44 45 46 47 48 49 50 51 ... 94 95

No comments

APC AP9212 Technical Information Page 46