APC 10-40kW 208/480V Installation Guide download pdf (Page 42)

42 Installation Guide Silcon DP300E 208V/480V 10-80 kVA

7OY0002 US rev. 04

6.0 Programming parameters

6.1 General

Below listed parameters can be programmed directly from the keyboard during the

commissioning.

Parameters are programmed as shown in the example 6.2.3.

6.2 Parameters

6.2.1

Parameter Setting* Comments

Bypass YES, NO “YES” will switch the system into

bypass mode

Language GB, D, F, Language of text in display

DK, S, SF

NL, PL, CZ

E, P, SK, H

Autostart YES, NO Automatic restart by mains return (1 min.

delay). Ensures quick battery recharge.

Remote shutdown YES, NO Shutdown of UPS by remote signal when in

active battery operation. Saves battery energy.

Remote shutdown HIGH, LOW Nature of remote shutdown signal polarity

polarity

Remote shutdown time 0, 1, 2, 3, 4 Time delay on remote shutdown of UPS

5, 6, 7, 8, 9

10 min.

Battery capacity test – Initiates check of back-up time. The

measured time is from start until it reaches

low DC warning level (Se section 8.4)

Battery monitor test** – Initiates checks of battery condition by

25% discharging.

Auto battery test** 3, 6 months Activates the battery monitor test in cyclic

OFF intervals (standard 3 months)

Battery monitor reset** – Pressing the

and key after

selecting this parameter resets alarms and

flushes messages in the alarm stack

Boost charge YES, NO “YES” results in boost charge (10 hours)

Autoboost charge YES, NO “YES” results in boost charge after battery

operation. (10 hours)

Enter new date YYMMDD Local date can be entered

Enter new time HHMMSS Local time can be entered

* Text in bold letters are the factory standard setting

** Only for systems with Battery Monitor active

Programming parameters

NOTE:

The system must not run in

bypass mode for longer periods

of time as the batteries will not

be recharged.

1 2 ... 37 38 39 40 41 42 43 44 45 46 47 ... 118 119

Comments to this Manuals

No comments

APC 10-40kW 208/480V Installation Guide Page 42

Comments to this Manuals

Related products and manuals for Power supply units APC 10-40kW 208/480V