198
Multicast MAC address must not be forwarded,
regardless of any dynamic information. A port
may not be added in this set if it is already a
member of the set of ports in EgressPorts.
Cautions
• An entry in this table shall not be applicable for a bridge port created
over PPPOE/IPOE interface.
References
• Bridge Commands
8.6.9 Bridge static ucast Commands
8.6.9.1 Get bridge static ucast
Description: Use this command to get.
Command Syntax: get bridge static ucast [vlanid <vlanid-val>]
[ucastaddr <ucastaddr-val>]
8.6.9.2 Create bridge static ucast
Description: Use this command to create.
Command Syntax: create bridge static ucast vlanid <vlanid-val>
ucastaddr <ucastaddr-val> [portid <portid-val>]
8.6.9.3 Delete bridge static ucast
Description Use this command to delete.
Command Syntax: delete bridge static ucast vlanid <vlanid-val>
ucastaddr <ucastaddr-val>
8.6.9.4 Modify bridge static ucast
Description Use this command to modify.
Command Syntax: modify bridge static ucast vlanid <vlanid-val>
ucastaddr <ucastaddr-val> [portid <portid-val>]
Parameters
Name Description
vlanid <vlanid-val>
The VLAN index referring to this VLAN. In case of
device capability not supporting vlans, vlan id "0"
is a valid value. VLAN here means the 802.1q
Vlan in case of Native Vlan mode and Virtual Vlan
in case of Stacked Vlan Mode.
Type: Create - Mandatory
Delete - Mandatory
Modify - Mandatory
Get - Optional
Valid values: 0 - 4095
ucastaddr <ucastaddr-
val>
The destination unicast MacAddr to which filtering
info applies.
Type: Create - Mandatory
Delete - Mandatory
Modify - Mandatory
Get - Optional
portid <portid-val>
The set of ports, for which a frame with a specific
unicast address will be flooded in the event that it
has not been learned. It also specifies the set of
ports a specific unicast address may be
dynamically learnt on. This list shall have only the
CPE side ports. Currently only one port can be set
in this list. Type: Create - Optional
Modify - Optional
Comments to this Manuals