APC IP DSLAM User's Guide download pdf (Page 482)

100

101

474

Agent Circuit Id : "[ANI] atm 3/10:100.33î (slot =

3, port = 10, vpi = 100, vci = 33)"

Remote Agent Id : "conexant noida"

SyncRateInfoField Bitmask : ActualDelaydnstrm

Act for IWFTag From Client : drop

Insert Iwf Subop : enable

Port No : 10

VCI : 33 VPI :

100

L2 type : Eth

Encap Type : Llcmux

Verbose Mode Off:

Entry Created

Output field

Field Description

Port Id

Bridge Port Identifier

VLAN

VLAN identifier. In case of stacked mode this is

virtual VLAN

Profile Id

PIA profile identifier. This shall be used for this

PIA Instance

PIA status

Used to enable or disable PPPOE

intermmediate agent for this instance

PIAVsaOption

This specifies the action to be performed on

VSA Tag on receiving PPPoE discovery packets

for this instance. If disabled PIA will not add VSA

tag to the PPPoE packets. If AddAlways is set

then VSA tag is always added. If AddIfNotExists

is set then VSA tag is added only if the received

packet does not contain the VSA tag.

Config Sub Options

Bitmask

This bitmask is used to indicate which all

parameters are configured for this instance.

Parameter bit set in this bitmask will overwrite

the automatically derived values of agent circuit

Id and/or port id by the values configured in this

MO.

Agent Circuit Id

This is use to configure Agent Circuit Id for this

instance. If ACI bit is set in

gsvPiaConfigSubOptionBitmask then this

parameter will overwrite the generated Agent

Circuit Id

Remote Agent Id

This is used to configure Remote Agent Id for

this instance. This parameter uniquely identifies

the subscriber on the associated access loop

logical port on Columbia.

SyncRateInfoField

Bitmask

This bitmask is used to indicate what all access

loop characteristic parameters are to be added

to access loop characteristic suboption.

Act for IWFTag From

Client

This field specifies the Action to be taken on

receiving PPPoE discovery msg with IWF

suboption from client. It can be configured as

either drop or forward. Default action is to drop

the packet silently.

Insert Iwf Subop

This is used to indicate whether to add IWF

suboption to Columbia originated PPPoE

discovery packets received for this instance.

This field is valid only for PPPOAE interface.

1 2 ... 477 478 479 480 481 482 483 484 485 486 487 ... 602 603

Comments to this Manuals

No comments

APC IP DSLAM User's Guide Page 482

Comments to this Manuals

Related products and manuals for Networking APC IP DSLAM