APC IP DSLAM User's Guide download pdf (Page 578)

570

Output field

Field Description

VLAN Name

An administratively assigned string, which may

be used to identify the VLAN. This is mandatory

in the case of create cmnd. In case of

get/modify/delete - either vlan name or vlan id

can be given.

VLAN Index

The VLAN Identifier.

GS_UNREGISTERED_VLANID is a special Vlan

Id used for managing the traffic for those VLANs

that are neither created nor learned in the

system. The valid range for this field also

includes GS_UNREGISTERED_VLANID

besides the range 1-4095.

Egress ports

The set of ports, which are permanently

assigned to the egress list for this VLAN by

management

Forbidden Egress Ports

The set of ports which are prohibited by

management from being included in the egress

list for this VLAN.

Untagged Ports

The set of ports, which should transmit egress

packets for this VLAN, as untagged.

Bridging Mode

This specifies the state of full bridging for the

VLAN. There can be three values associated

with this, based on global fullBridgingStatus.

These values can be restricted bridging,

unrestricted full bridging and residential bridging.

If the user does not specify the bridging mode at

the time of VLAN creation, the VLAN inherits the

globally set bridging mode. The user can modify

bridging mode for a created VLAN. If the

dynamic entry for the VLAN to be created

already exists, the user can only specify globally

set bridging mode for this VLAN. The bridging

modes are defined as Restricted Full Bridging,

Unrestricted full bridging and Resedential

bridging. The default residential VLAN, like any

other residential VLAN allows only one net side

bridge port as its member. This port shall be

added automatically to the default VLAN if it is

the only net side bridge port being added to the

VLAN. Subsequently, the user can add another

net side port to the egressportslist and

untaggedportslist only after removing the

previously added net side bridge port.

Unrestricted bridging is not applicable for bridge

ports created over the PPPoE interface even

though the VLAN may be unrestricted.

Flood support Status

This specifies if the flooding has to be done for

unknown unicast packets for this vlan or not.The

default value for this shall be taken from enable

when vlan is created. The unknown unicast

packets shall be flooded on all ports for a vlan if

global value (present inDot1dTpInfo)is enabled

or throttle, and the value pervlan is also enabled

else dropped.

Broadcast support

Status

This specifies if the broadcast has to be done for

this vlan or not. The default value for this shall

be taken from enable when vlan is created. The

broadcast packets shall be flooded on all ports

for a vlan if global value (present in Dot1dTpInfo)

and the value per vlan are both enabled else

dropped.

Reserved Mac Profile Id

The Profile associated with this Vlan to be used

1 2 ... 573 574 575 576 577 578 579 580 581 582 583 ... 602 603

Comments to this Manuals

No comments

APC IP DSLAM User's Guide Page 578

Comments to this Manuals

Related products and manuals for Networking APC IP DSLAM