APC AP7602 Instruction Manual Page 129

  • Download
  • Add to my manuals
  • Print
  • Page
    / 294
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 128
Mass Configuration: Sensor and Alert Settings
128 InfraStruXure Central 4.0 User’s Reference
6. Type the appropriate values in the fields.
7. Specify Advanced Scheduling for the Periodic Report (optional). By default, all Periodic Reports
will be generated according to the Interval value you specify. However, you can specify that a
Periodic Report will be active only occur during specific time ranges. To configure Advanced
Scheduling:
a. Click Advanced Scheduling.... The Advanced Scheduling window opens.
b. By default, all time periods in the schedule are set to Enabled. To disable the Periodic Report for
a currently enabled period of time, highlight the period of time by clicking-and-dragging over the
desired time range, and then click Disable. To enable the Periodic Report for a currently disabled
period of time, highlight the period of time by clicking-and-dragging over the desired time range,
and then click Enable.
c. When you have finished creating your Advanced Schedule, click OK to save the schedule and
return to the Periodic Report task.
When you are finished, click OK to save this entry to selected devices. Click Cancel to close this window
without saving any changes.
Configuring Sensors and Thresholds
The majority of tasks that are available from the Sensor & Alert Settings pane enable you to configure the
sensors that are built into or connected to your NetBotz devices. Each sensor threshold configuration task
is named for the type of sensor with which the sensor will be used (temperature, air flow, humidity, and so
forth).
Page view 128
1 2 ... 124 125 126 127 128 129 130 131 132 133 134 ... 293 294

Comments to this Manuals

No comments