APC AP7602 Instruction Manual download pdf (Page 143)

Mass Configuration: Sensor and Alert Settings

142 InfraStruXure Central 4.0 User’s Reference

desired time range, and then click Disable. To enable the threshold for a currently disabled

period of time, highlight the period of time by clicking-and-dragging over the desired time

range, and then click Enable.

c.When you have finished creating your Advanced Threshold, click OK to save the schedule and

return to the Thresholds task.

– Select an Alert Severity value for this threshold. Available Alert Severities are, in order of

escalating severity: Information, Warning, Error, Critical, or Failure. By default, the Alert

Severity generated by this threshold will be “Error.”

– Select Cameras to Trigger in response to the alert. To include images from one or more connected

NetBotz Camera Pod 120s, check the check boxes that correspond to the desired pods.

– Specify a User-specified URL and User-specified Description. You can use these fields to include

additional user-specific information with any alert notifications that are generated using this

threshold.

– Check the Return-To-Normal Requires User Input check box. When checked, if this threshold is

exceeded the sensor will not report a Return-To-Normal state until a user with Administrator or

Application (with Alert Update) privileges opens the resulting alert entry in the Alerts View and

clicks the Mark Alert Resolved button.

7. Click OK to save this threshold.

Rate of Decrease Threshold

A rate of decrease threshold is defined by specifying a maximum acceptable decrease in value for

selected sensors and a period of time value. If the value reported by the sensor falls by more than the

specified maximum acceptable decrease in less than the specified period of time an alert condition is

reported.

1 2 ... 138 139 140 141 142 143 144 145 146 147 148 ... 293 294

No comments

APC AP7602 Instruction Manual Page 143