APC AP7602 Instruction Manual download pdf (Page 140)

Mass Configuration: Sensor and Alert Settings

InfraStruXure Central 4.0 User’s Reference 139

b. Type in the Time Allowed Above Maximum field (or use the arrows in the field to specify) the

number of seconds that the reported value can exceed the value specified in the Maximum field

before an alert condition is generated.

c. Check the Enabled check box to enable the threshold. If this check box is not checked, the alert

threshold will be saved but will not be active.

Add to the Threshold-Specific Addresses list the e-mail addresses of any personnel to whom e-

mail alert notifications should be sent if this threshold triggers an alert condition. Click Add...,

type in the e-mail address to which the alert notification will be sent, and then click OK.

If you’ve installed an SMS-capable modem you can deliver alert notification to SMS-enabled

devices by entering threshold-specific addresses for them in the following format:

sms:sms_device_address

where sms_device_address is the telephone number or e-mail address associated with the SMS-

enabled device (for example, “sms:5123334444” or “sms:[email protected]”).

6. If desired, specify Advanced Threshold settings. All Advanced threshold settings are optional. From

the Advanced tab in the Thresholds pane:

– Specify a Return To Normal Delay value. Use the controls to specify the number of seconds that

must pass after this threshold has returned to normal before the threshold state is considered

returned to normal. Default value is 0 (state returns to normal immediately after the measured

value is no longer violating the threshold).

– Set an Advanced Schedule for this threshold (optional). By default, all thresholds are assumed to

be enabled 24 hours a day, 7 days a week. However, you can specify that a threshold will be

enabled only during specific time ranges. To set an Advanced Schedule:

a.Click Advanced Schedule....The Schedule Threshold window opens.

b.By default, all time periods in the schedule are set to Enabled. To disable the threshold for a

currently enabled period of time, highlight the period of time by clicking-and-dragging over the

desired time range, and then click Disable. To enable the threshold for a currently disabled

period of time, highlight the period of time by clicking-and-dragging over the desired time

range, and then click Enable.

Note

These threshold-specific notifications are sent only if your device has one or more Alert

Actions defined that use the Send E-Mail Message alert notification method and that have

the Include Addresses from Thresholds check box checked. For more information, see

“Alert Actions” on page 113 and “Creating Alert Actions” on page 221.

1 2 ... 135 136 137 138 139 140 141 142 143 144 145 ... 293 294

No comments

APC AP7602 Instruction Manual Page 140