APC AP7602 Instruction Manual download pdf (Page 144)

Mass Configuration: Sensor and Alert Settings

InfraStruXure Central 4.0 User’s Reference 143

To define a rate of decrease threshold:

1. Launch the Sensor & Alert Settings task that corresponds to the numeric-based sensor for which

you will define a threshold.

2. Select Rate of Decrease Threshold from the Threshold drop box. Any selected devices that have

previously defined rate of decrease thresholds will be listed in the Management Devices list.

3. Select the desired threshold operation and targets:

– If you are editing one or more previously defined rate of decrease thresholds, select the devices

on which the threshold has been configured from the Management Devices list and then click

Edit.

– If you are defining a new rate of decrease threshold click Add. Then, select one or more devices

for which this threshold will be configured, and click Next. Finally, select the sensors on the

selected devices for which this threshold will be configured and then click Next.

4. Type in the Threshold Name field a name for this threshold.

5. Specify Basic threshold settings. From the Basic tab in the Thresholds pane:

a. Type in the Maximum Decrease field (or use the arrows in the field to specify) the highest

acceptable change value for the selected sensors. If the value reported by the sensor decreases by

more than the Maximum Decrease value in a period of time that is equal to or less than the

number of seconds specified in the Time Period field, an alert condition results.

b. Type in the Time Period field (or use the arrows in the field to specify) the number of seconds

that defines the unacceptable change period. If the value reported by the sensor decreases by

more than the Maximum Decrease value in a period of time that is equal to or less than the Time

Period value an alert condition is generated.

c. Check the Enabled check box to enable the threshold. If this check box is not checked, the alert

threshold will be saved but will not be active.

Add to the Threshold-Specific Addresses list the e-mail addresses of any personnel to whom e-

mail alert notifications should be sent if this threshold triggers an alert condition. Click Add...,

type in the e-mail address to which the alert notification will be sent, and then click OK.

If you’ve installed an SMS-capable modem you can deliver alert notification to SMS-enabled

devices by entering threshold-specific addresses for them in the following format:

sms:sms_device_address

where sms_device_address is the telephone number or e-mail address associated with the SMS-

enabled device (for example, “sms:5123334444” or “sms:[email protected]”).

6. If desired, specify Advanced Threshold settings. All Advanced threshold settings are optional. From

the Advanced tab in the Thresholds pane:

– Specify a Return To Normal Delay value. Use the controls to specify the number of seconds that

must pass after this threshold has returned to normal before the threshold state is considered

Note

These threshold-specific notifications are sent only if your device has one or more Alert

Actions defined that use the Send E-Mail Message alert notification method and that have

the Include Addresses from Thresholds check box checked. For more information, see

“Alert Actions” on page 113 and “Creating Alert Actions” on page 221.

1 2 ... 139 140 141 142 143 144 145 146 147 148 149 ... 293 294

Comments to this Manuals

No comments

APC AP7602 Instruction Manual Page 144

Comments to this Manuals

Related products and manuals for Power supply units APC AP7602