APC IP DSLAM User's Guide download pdf (Page 356)

348

Value 32 is meant for internal purpose and

Agents should not pass this value to GAG. GAG

may return 32 value to Agent, in which case

Agent should treat it as invalid.

Type: Create -- Optional

Modify -- Optional

Valid values: 0 - 31

Default value: ---

mplr <mplr-val>

Multiplier, is used to multiply the value shifted by

ShiftCount. It is used to calculate the new base

offset. This field is valid only if the

gsvClfrProfileNodeAction is SetBase.

Type: Create -- Optional

Modify -- Optional

Valid values: 1 - 32

Default value: ----

Modmask

Act|ValType|Offset|Mask

|Val|None|ValueEnd|Sbt

ype|SBShiftCnt|SBMlpr|

Descrip

This specifies what fields of an exported node

are modifiable and can be modified while the

profile is part of a classifier tree.

Type: Create -- Optional

Modify -- Optional

Actval

Drop|Fwd|FwdToCtl|CpT

oCtl|Eq|Gt|Lt|InRange|Te

rCmp|

SetPrio|MatchInList|Acc

Deny|SetBase|Count|

Retagprio |

MatchIngenlist

|GoToNextRule|allow

Action tells what is to be done by a node. 'Drop'

means drop the packet. 'Fwd' means Forward

the packet. 'FwdToCtl' means Forward the

packet to control plane. 'CpToCtl' means forward

the packet and also send a copy of the packet to

control plane.'Allow' means give the packet to

the next stage. 'GoToNextRule' means go to the

next rule (ruleid) attached on that interface and if

no next rule is attached on that interface then

forward the packet. 'Eq' means check if value

specified in the packet is equal to 'Value'. 'Gt'

means check if the value at the location

specified in the packet is greater than 'Value'. 'Lt'

means check if the value at the location

specified in the packet is Less than 'Value'.

'InRange' means check if the value at the

location specified in the packet is in the range

specified by 'Value' and 'ValEnd'. 'TerCmp'

means check if the value at the location

specified in the packet is less than, equals to or

greater than the 'Value'. 'MatchInList' means

take the branch of the node whose value is

equals to the value at the location specified in

the packet. 'AccDeny' means check if the value

at the location specified in the packet is equals

to any of the value of the branches of this node.

'SetBase' means set the base address as

specified by 'setbase action'. 'SetPrio' means set

the internal priority, which is used along with

egress port traffic class mapping table, to

determine the output queue. 'Count' means

count the number of packet and bytes in the

packets reaching this nodes. 'RetagPrio' means

set the priority in the outgoing packet, which is

also used along with egress port traffic class

mapping table, to determine the output queue.

'MatchInGenList' means match value in packet

with values in genlist. For Leaf node, Drop, Fwd,

FwdToCtl, CpToCtl, Allow and GoToNextRule

are valid actions. For Unary node, Count,

SetPrio and RetagPrio are valid actions. For

Binary node, Eq, Gt, Lt, SetBase and

1 2 ... 351 352 353 354 355 356 357 358 359 360 361 ... 602 603

Comments to this Manuals

No comments

APC IP DSLAM User's Guide Page 356

Comments to this Manuals

Related products and manuals for Networking APC IP DSLAM