APC IP DSLAM User's Guide Page 268
- Page / 603
- Table of contents
- BOOKMARKS
Rated. / 5. Based on customer reviews
260
Trans Atuc Actual : q9921PotsNonOverlapped
Trans Atuc Config : ansit1413
GsDmtTrellis : trellisOn
Trans Atur Cap : ansit1413
PM Conf PMSF : idleop
Line DELT Conf LDSF : inhibit
Curr Output Pwr(dBm/10) : 10 DS Bin SNR
Update : Enable
Bin Number SNR Margin/bin
---------------------------------
[ 0] 16
Oper Status : Up Admin
Status : Enable
Output Fields
FIELD Description
IfName
The interface name of the DSL port.
Line Type
Line type used by the DSL port.
Coding Type
Line coding type used by the port.
GsUtopia L2TxAddr
UTOPIA Level 2 Tx address for a line.
GsUtopia L2RxAddr
UTOPIA Level 2 Rx address.
GsUtopia
L2RxAddr2nd
Conexant parameter to set UTOPIA Level 2 Rx
address for the secondary bearer channel in case
of Dual Latency. (length = 4 bytes)
GsUtopia
L2TxAddr2nd
Conexant parameter to set UTOPIA Level 2 Tx
address for the secondary bearer channel in case
of Dual Latency. (length = 4 bytes)
Gs Clock Type
Indicates use of crystal or oscillator.
Gs Action
Allows action on per-line basis.
Trans Atuc Cap
Transmission modes that ATU-C is capable of.
Trans Atuc Actual
Transmission modes
Trans Atuc Config
The transmission modes that the ATU-C is
capable of supporting. The modes available are
limited by the design of the equipment.
REFERENCE"Section 7.3.2 ITU G.997.1" (length
= 4 bytes).
GsDmtTrellis
Indicates whether trellis coding has been enabled
or not.
Trans Atur Cap
The transmission modes that the ATU-R is
capable of supporting. The modes available are
limited by the design of the equipment (length = 4
bytes).
PM Conf PMSF
PM-related parameter used by ATU-C to force a
change in the line state. (Not available for
ADSL/ADSL2Plus)
Line DELT Conf LDSF
The DELT-related parameter used by ATU-C to
force the line into the loop diagnostics mode. (Not
available for ADSL and ADSL2plus)
Curr Output
Pwr(dBm/10)
This conexant parameter indicates the measure of
total output power transmitted by this ATU. The
value of this parameter is dynamic and will also
show the change in Tx power due to Power
Management. For example, the value will
decrease in L2 low power mode. This value can
- ADSL2+/G.SHDSL.bis 1
- IP DSLAM 1
- 1 About This Manual 9
- Document Conventions 10
- 2 What’s the difference 11
- DSLAM and IP based 11
- DSLAM? 11
- ADSL2/2+ IP DSLAM 12
- 3 Introduction 14
- 4 Getting Started 22
- 4.3 Hardware Installation 24
- 5 EMS Configuration 29
- 5.2 Windows Arrangement 40
- 5.3 Help 41
- 5.4 Tools Menu Introduction 42
- 6 Manage the ADSL2/2+ IP 59
- 6.2 Default Setting 61
- 6.3 System Information 62
- 6.4 Current Event 64
- 6.5 System 67
- 6.6 Configuration 67
- 6.7 DSL 73
- 7 Application Note 85
- Application Note 100
- 7.2 Advanced Configuration 114
- 8 System Administration with 143
- CLI Command - Action List 146
- Temperature State 152
- 8.2 802.1p Commands 153
- DefaultSVPriority : 1 154
- TrafficClass : 2 155
- RegenUserPrio : 1 156
- 8.3 ABOND Commands 157
- Entry Created 162
- 8.4 Aggregation Commands 165
- Get rdncy aggr info 175
- Create rdncy aggr info 175
- Delete rdncy aggr info 175
- Modify rdncy aggr info 175
- Get rdncy aggrport list 177
- Get rdncy aggr stats 178
- Reset rdncy aggr stats 178
- 8.5 ATM Commands 179
- Modify oam cc vc 180
- Verbose Mode Off: 184
- Output Fields 184
- Parameters 186
- 8.6 Bridging Commands 193
- Bridging Mode is Enabled 194
- Portid : 45 195
- Status : Mgmt 196
- Port Id : 2 207
- Set Done 214
- Egress ports : 1 2 221
- Group Learnt : 1 221
- 8.8 DHCP Commands 226
- 8.9 DSL Commands 228
- Example 230
- AtucChanGsB0dn : 10 238
- IntervalLESs(sec) : 10 256
- Tx Cap: Region1 294
- Output field 297
- • DSL Commands 326
- 8.10 EHDLC Commands 327
- 8.11 Ethernet Commands 329
- References 340
- • Ethernet stats command 340
- 8.12 EOA Commands 341
- • Ethernet commands 343
- • Ethernet Stats commands 343
- 8.13 Filtering Commands 344
- Get clfr namedlist genentry 347
- Create clfr namedlist map 349
- Delete clfr namedlist map 349
- <listid-val> 350
- Delete clfr profile branch 351
- Create clfr profile info 352
- Modify clfr profile info 352
- Create clfr profile node 353
- Delete clfr profile node 353
- Modify clfr profile node 354
- 356
- Mask : 0xffff 358
- <offset 364
- SetBase 368
- Create filter list genentry 371
- Delete filter subrule arp 388
- Id : 2 420
- • Generic Filter Commands 424
- 8.14 IGMP Commands 425
- Caution 437
- 8.15 Interface Commands 438
- IfName LinkUp/DnTrap 440
- 440
- 8.16 IP Commands 441
- RID : 1 449
- MacProfile Commands 451
- 0xffffffff 459
- DRA Nack Count : 50 469
- PIA global Status : Enable 484
- 8.21 QoS Commands 485
- Id : 1 500
- Thresh : 50 500
- 8.22 RMON Commands 503
- SUSPEND 504
- Get rmon mpool 505
- Pool Type : PARTITION 509
- Task Name : TSK1 509
- Mpool Name : FTSK143 509
- First Task 515
- 8.23 SNMP Commands 517
- 8.24 SNTP Commands 523
- 8.25 System Commands 525
- CP Bin Version : 1.6 541
- DP Bin Version : 1.8 541
- 0xFFFF 544
- Name– aal5-0 549
- Get system version 557
- 8.26 VC Aggregation Commands 560
- 8.27 VLAN Commands 564
- • GVRP Commands 567
- • VLAN commands 580
- 8.28 Miscelleneous Commands 581
- Download Completed 583
- Verbose Mode Off 585
- File removed 589
- File upgraded 589
- Over a maximum of 30 hops 594
- Trace complete 594
- 9 FD.cfg in detail 596
- 10 Supported mibs 602
Related products and manuals for Networking APC IP DSLAM
Networking APC AP9606 Quick Start Manual
(20 pages)
(20 pages)
Networking APC AP9312TH User's Guide
(32 pages)
(32 pages)
Networking APC AP9608 Installation Manual
(32 pages)
(32 pages)
Networking APC 66123 Installation Manual
(16 pages)
(16 pages)
Networking APC AP9630 User's Guide
(85 pages)
(85 pages)
Networking APC IP DSLAM User's Guide
(67 pages)
(67 pages)
Networking APC AP9630 User Manual
(117 pages)
(117 pages)
Networking APC AP9630 User Manual
(32 pages)
(32 pages)
Networking APC AP9224110 Specifications
(16 pages)
(16 pages)
Networking APC AP9608 Specifications
(9 pages)
(9 pages)
Networking APC AP9608 User Manual
(4 pages)
(4 pages)
© 2020, manymanuals.com. All rights reserved. | 0.178 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals