APC IP DSLAM User's Guide download pdf (Page 311)

303

TxFrmrPulseDelay

This parameter is for Serial ATM applications

only. It is recommended that the default value be

used. For special customer configurations, a

delay of up to 7 clock cycles can be specified for

the transmit frame pulse.

RxFrmrPulseDelay

This parameter is for Serial ATM applications

only. It is recommended that the default value be

used. For special customer configurations, a

delay of up to 7 clock cycles can be specified for

the receive frame pulse.

Multi Frame Mode

This object specifies the multi frame operational

mode of the transceiver.

4_6Mbps Bit Rate

This object specifies the operational state of the

4_6Mbps bit rate.

Tom Data Word1

This object identifies one of four words of

proprietary vendor data, as described in the

Vendor Data section of ITU-T G.994.1.bis.

Tom Data Word2

This object identifies one of four words of

proprietary vendor data, as described in the

Vendor Data section of ITU-T G.994.1.bis.

Tom Data Word3

This object identifies one of four words of

proprietary vendor data, as described in the

Vendor Data section of ITU-T G.994.1.bis.

Tom Data Word4

This object identifies one of four words of

proprietary vendor data, as described in the

Vendor Data section of ITU-T G.994.1.bis.

ReqSilenceMode

This object enables a silent mode for the STU at

the opposite end of the loop for approximately

one minute. During the silent period, the STU

that requested the silent mode could perform

whatever operations it wants and the STU at the

opposite end will remain in handshake.

Individual Rates1

This item enables the user to individually enable

or disable base rates for N=1 through N=16. The

default is all rates enabled.

Individual Rates2

This item enables the user to individually enable

or disable base rates for N=17 through N=32.

The default is all rates enabled.

IndividualRates3

This item enables the user to individually enable

or disable base rates for N=33 through N=36.

The default is all rates enabled.

SrlAtmCellDelineation

This object enables the user to enable or disable

cell delineation for serial ATM operation. This

parameter should be set before a startup.

FrmrCellDropOnErr

This object determines whether cells are

dropped, i.e., not passed to the host, or not

dropped, i.e., passed to the host. This object

must be set prior to startup.

Gear Shift Type

This object specifies the Gear Shift Type.

Hs Nsf

This object enables or disables nonstandard

Information fields for MP, MS, CL, and CLR

messages, as defined in ITU-T G.994.1.bis.

Hs Max Bits Per Baud

This object specifies the maximum bit per baud.

Hs Customer Id

This object identifies the customer identification

during handshaking, as described in ITU-T

G.994.1.bis.

Hs Customer Data0

This object identifies two words of customer data

during handshaking, as defined in ITU-T

1 2 ... 306 307 308 309 310 311 312 313 314 315 316 ... 602 603

Comments to this Manuals

No comments

APC IP DSLAM User's Guide Page 311

Comments to this Manuals

Related products and manuals for Networking APC IP DSLAM