APC IP DSLAM User's Guide download pdf (Page 317)

100

101

309

defined in ITU-T G.991.2, for the STU at the

other end of the loop.

RemProviderCode

This object identifies the provider code word, as

defined in ITU-T G.991.2, for the STU at the

other end of the loop.

Loc Detect

This object is used to determine if carrier has

been lost.

Tx Power

This object identifies the local STU transmit

power in tenths of a dBm.

FrmrSync

This object returns information regarding the

framer synchronization status.

RemTomData

This object provides vendor-provided data, as

defined in ITU-T G.991.2, for the STU at the

other end of the loop.

Drift Alarm

This object identifies if the receive clock is in or

out of range.

RecvGain

This object provides the total receiver gain in

dB.

Bert Error

This object provides the count of bit errors since

the last time the object was read, as well as the

type of synchronization.

RemFwVer

This object provides the transceiver firmware

release number of the STU at the other end of

the loop.

Utopia CD

This object indicates whether cell delineation

has been found.

UtopiaRxCellCnt

This object indicates the number of UTOPIA

cells received since the last time the object has

been called. The maximum value is 0xFFFF.

UtopiaCellDropCnt

This object indicates the number of UTOPIA

cells dropped since the last time the object has

been called. The maximum value is 0xFF.

UtopiaRxHECErrCnt

This object indicates the number of UTOPIA

cells with HEC errors since the last time the

object has been called. The maximum value is

0xFF.

UtopiaTxCellCnt

This object indicates the number of UTOPIA

cells transmitted since the last time the object

has been called. The maximum value is 0xFFFF.

RemNsfCusId

This object returns the customer identification

that was sent by the STU at the other end of the

loop.

RemTxPower

This object provides the transmit power of the

STU at the other end of the loop.

RemPowerBackoff

This object indicates whether power backoff is

enabled or disabled at the STU at the other end

of the loop.

AutoRetrainCnt

This object indicates the number of automatic

retrains. This counter is only reset when a

startup is initiated.

Eoc State

This object provides status information about

the eoc stage.

Ntr Fault

This object identifies the Network Timing

Recovery Fault.

ParamTestResult

Indicates the Result of the Parametric Test

conducted on the Xcvr.

1 2 ... 312 313 314 315 316 317 318 319 320 321 322 ... 602 603

Comments to this Manuals

No comments

APC IP DSLAM User's Guide Page 317

Comments to this Manuals

Related products and manuals for Networking APC IP DSLAM