APC IP DSLAM User's Guide Page 464

  • Download
  • Add to my manuals
  • Print
  • Page
    / 603
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 463
456
Ifname : pppoe-0 Low If Name :
ppp-0
WAN Bridge Port : 1 Session Id : 10
AC Mac Addr : 00:0E:7F:61:C1:BE Mac Addr Prof : 1
Service Name Profile : 2
AC Name Prof : 4
Eth Pkt Type : Type2 Nature :
dynamic
Oper Status : Up Admin Status :
Enable
Verbose Mode Off:
Entry Created
Output Fields
FIELD Description
Ifname
The PPPoE Interface.
Low If Name
This specifies the lower interface index. It
contains the ifindex of the PPP relay interface.
WAN Bridge Port
WAN side bridge port. A value of zero means
any WAN side port is acceptable. Currently, only
value zero is supported.
Session Id
Session Id for the session given only in case a
static session is being created.
AC Mac Addr
MAC address of the remote AC given only in
case a static session is being created.
Mac Addr Prof
Profile Id for self MAC addresses. The profile for
the same is created using the
PPPoEMacAddrProfileTable.
Service Name Profile
Profile Id related to Service Name for the
Session based on which the AC is selected.The
Profile for the same is created using the
PPPoESessionProfileTable. A value of "any"
means no specific service is needed to select an
AC. A value of "anyconfigured"means any
configured service name profile can be used for
selecting an AC.
AC Name Prof
Profile Id related to AC Name for the Session
based on which the AC is selected. The Profile
for the same is created using the
PPPoEAcProfileTable. A value of "any" means
no specific AC is needed for establishing a
session on the WAN side. A value of
"anyconfigured"means any configured AC name
profile can be used for selecting an AC.
Eth Pkt Type
This specifies the type of the packet.
Nature
Specifies if the interface is dynamic or static in
nature. The session is assumed to be in
established state when the interface is static in
nature.
Oper Status
The actual/current state of the interface. It can
be either up or down.
Admin Status
The desired state of the interface. It may be
either Up or Down.
References
PPPoE session config related commands.
8.19.6 PPPoE Session Stats Commands
8.19.6.1 Get pppoe session stats
Description: Use this command to get.
Command Syntax: get pppoe session stats [ifname <interface-
name>]
Page view 463
1 2 ... 459 460 461 462 463 464 465 466 467 468 469 ... 602 603

Comments to this Manuals

No comments