APC IP DSLAM User's Guide download pdf (Page 492)

100

101

484

description

<description-val>

Description of the application that receives

packets matching this RL. This field is mandatory

if Action is 'sendtocontrol' or 'copytocontrol'.The

description string should not begin with

underscore '_' as it is reserved for special usage

e.g. _PPPOE_CONTROL.

Type: Create -- Optional

Modify -- Optional

Default value: "\0"

Example

$ create rl actionprofile info profileid 1 result conform action

copytocontrol actionval 0x00000000 actionmask 0xffffffff description

lacp

Output

Verbose Mode On

Entry Created

Action Profile Id : 1 Action Result :

conform

Profile Action : copytocontrolActionVal :

0x00000000

Action Mask : 0xffffffff Application Description :

lacp

Verbose Mode Off:

Entry Created

Output field

Field Description

Action Profile Id

Rate limiter's action profile identifier, which

uniquely identifies the action profile.

Action Result

The result type for which action is configured to be

taken. Multiple actions can be configured for a

result type.There shall be multiple entries with

same profile identifier and a result type if multiple

actions are configured for the result type. If there

is no entry configured for a result type, the action

is assumed to be 'allow' for that result.

Profile Action

Action to be taken on the packet.

ActionVal

The parameter should contain valid value for

some actions that require an additional input.For

sendtocontrol and copytocontrol actions this

parameter should contain control flow id (0 - 3).

Other values are invalid for this action. For

modifytos action this parameter should contain

value to be set in tos field in the packet in the

range 0 to 255. Other values are invalid for this

action. The application of this value is dependent

on the mask field. For setbaclevel action this

parameter should contain Buffer Admission

Control level 0 or 1. Other values are invalid for

this action. This parameter is ignored for other

actions.

Action Mask

This field is valid for sendtocontrol, copytocontrol

and modifytos actions only.For sendtocontrol and

copytocontrol actions this parameter should

contain trap disabled (0xffffffff) or trap enabled

(0x00000000). Other values are invalid for this

action.Only lower 8-bits are taken into

1 2 ... 487 488 489 490 491 492 493 494 495 496 497 ... 602 603

Comments to this Manuals

No comments

APC IP DSLAM User's Guide Page 492

Comments to this Manuals

Related products and manuals for Networking APC IP DSLAM