APC IP DSLAM User's Guide download pdf (Page 569)

100

101

561

8.27.4 Vlan curr info Commands

8.27.4.1 Get vlan curr info

Description: Use this command to get.

Command Syntax: get vlan curr info [vlanid <vlanid

-val >]

Parameters

Name Description

vlanid <vlanid-val >

The VLAN Identifier.

Type: Get -- Optional

Valid values: 1 - 4095

Example

$ get vlan curr info vlanid 45

Output

VLAN Index : 45

VLAN Status : 1

Egress Ports : 24

Untagged Ports : 24

Bridging Mode : Residential

Flood support Status : enable

Broadcast support Status : enable

Reserved Mac Profile Id : 1

Output field

Field Description

VLAN Index

The VLAN identifier

VLAN Status

This value indicates the status of the VLAN Port

corresponding to this entry. Other (1) - the entry is

for the default VLAN created for the system.

Permanent (2) - this entry, corresponding to an

entry in dot1qVlanStaticTable, is currently in use

and will remain so after the next reset of the

device. The port lists for this entry include ports

from the equivalent dot1qVlanStaticTable entry

and ports learnt dynamically. Dynamic (3) - this

entry is currently in use and will remain so until

removed by GVRP. There is no static entry for

this VLAN and it will be removed when the last

port leaves the VLAN.

Egress Ports

The set of ports, which are transmitting traffic for

this VLAN, as either tagged or untagged frames.

Untagged Ports

The set of ports, which are transmitting traffic for

this VLAN as untagged frames. In Stacked Vlan

mode this applies tagging/untagging for C-VLAN.

Bridging Mode

This specifies the state of full bridging for the Vlan.

There can be 3 values associated with this based

on global fullBridgingStatus. These values can be

restricted bridging, unrestricted full bridging and

residential bridging. The user can specify the

bridging mode for the vlan in the

Dot1qVlanStaticTable table as one of these

values; otherwise the vlan inherits the globally set

bridging mode. Unrestricted bridging is not

applicable for bridge ports created over pppoe

interface even though the vlan may be

unrestricted.For a Vlan with bridging mode as

CrossConnect there is no learning and lookup and

there are at most two member ports for it. In band

Management traffic cannot run for such a vlan.

VLAN here means the 802.1q vlan in case of

Native Vlan mode and Virtual Vlan in case of

Stacked Vlan Mode.

1 2 ... 564 565 566 567 568 569 570 571 572 573 574 ... 602 603

Comments to this Manuals

No comments

APC IP DSLAM User's Guide Page 569

Comments to this Manuals

Related products and manuals for Networking APC IP DSLAM