APC InfraStruXure Power Supply Specifications download pdf (Page 42)

36 InfraStruXure 20kW System: Installation, Operation, and Maintenance

Control Console

Local access to the control console

You can use a local computer, to connect to the system through the serial port to access the control

console.

1. Select a serial port at the local computer and disable any service that uses that port.

2. Disconnect the display interface.

3. Connect the smart-signaling cable (940-0024) that came with the system to the selected serial

port at the local computer and to the serial port at the system’s Display/Computer Interface

Card.

4. Run a terminal program (such as HyperTerminal) and configure the selected port for 2400 bps,

8 data bits, no parity, 1 stop bit, and no flow control, and save the changes.

5. Press

ENTER to display the User Name prompt.

6. Use apc for the user name and password.

7. See “Configuring settings on the control console” on page 37 to finish the configuration.

Remote access to the control console

From any computer on the same subnet as the system, you can use ARP and Ping, to assign an IP

address to a system, and then use Telnet to access that system’s control console and configure the

needed TCP/IP settings.

1. Use

ARP to define an IP address for the system, and use the system’s MAC address in the ARP

command. For example, to define an

IP address of 159.215.15.141 for a system that has a MAC

address of 00 c0 b7 63 9f 67, use one of the following commands:

– Windows command format:

arp -s 159.215.15.141 00-c0-b7-63-9f-67

– LINUX command format:

arp -s 159.215.15.141 00:c0:b7:63:9f:67

Note

After a system has its IP address configured, you can use Telnet, without first

using ARP and Ping, to access that system.

The InfraStruXure 20kW System quality assurance test slip lists the MAC

address.

1 2 ... 37 38 39 40 41 42 43 44 45 46 47 ... 91 92

No comments

APC InfraStruXure Power Supply Specifications Page 42