APC InfraStruXure Power Supply Specifications Page 88
- Page / 92
- Table of contents
- TROUBLESHOOTING
- BOOKMARKS
Rated. / 5. Based on customer reviews
82 InfraStruXure 20kW System: Installation, Operation, and Maintenance
Life-Support Policy
APC three-phase systems
American Power Conversion Corporation (APC) and its affiliates and subsidiaries worldwide do not
recommend the use of any of their products in life-support applications where failure or malfunction
of the APC product can be reasonably expected to cause failure of the life-support device or to
significantly affect its safety or effectiveness. APC does not permit the use of any of its products in
direct patient care. APC will not knowingly sell its products for use in such applications unless the
life-support system or direct patient care device is part of a whole facility/building into which the
UPS is integrated, and unless APC receives, in writing, assurances satisfactory to APC that:
a. The UPS system will be configured in a manner that will provide N+1 power redundancy to
the critical load,
b. The end-user customer assumes all risks and signs the APC System Configuration and Use
Form, and
c. The customer and operators of the APC UPS system agree to indemnify and hold APC and
its affiliates and subsidiaries harmless for any and all claims arising out of the systems use in
such applications.
Examples of life-support devices include, but are not limited to, neonatal oxygen analyzers, nerve
stimulators (whether used for anaesthesia, pain relief, or other purposes), auto-transfusion devices,
blood pumps, defibrillators, arrhythmia detectors and alarms, pacemakers, hemodialysis systems,
peritoneal dialysis systems, neonatal ventilator incubators, ventilators for both adults and infants,
anaesthesia ventilators, infusion pumps, and any other device designated as “critical” by the
U.S.F.D.A.
Hospital-grade wiring devices and leakage current may be ordered as options on many APC UPS
systems. APC does not claim that units with this modification are certified or listed as hospital-grade
by APC or any other organization. Therefore, these units do not meet the requirements for use in
direct patient care.
- InfraStruXure 20kW System 1
- Contents 3
- Warnings 8
- Total power off procedure 9
- Batteries—CAUTION 9
- Emergency Power Off (EPO) 9
- Handling and transport 10
- Overview 11
- Front view (interior) 12
- Front view (lower interior) 13
- Rear view 14
- Main input connection options 15
- Site Planning 17
- Electrical requirements 18
- Heat output 18
- Installation 19
- Ensure that all power is off 21
- Normally Open (NO) 25
- EPO Control 25
- Normally Closed (NC) 25
- System Start-Up 31
- Start-Up Procedure 32
- Top-Level Status Screen 34
- Top-Level Menu 34
- Control Menu 34
- Apply power to load equipment 35
- Quick Configuration 37
- Interface 38
- APC Management Card Wizard 39
- 01) is the code 41
- 04) is the length 41
- Control Console 42
- IP address. For example: 43
- 20kW System 44
- Operation 45
- Navigating screens 46
- Top-Level Status screen 47
- Top-Level Menu screen 47
- Control screen 48
- Status screens 48
- Setup screen 49
- Accessories screen 50
- NTER key to view a 51
- NTER key. Then press the 52
- Procedures 53
- Operation: Procedures 54
- DC Disconnect breaker to OFF 55
- 6. Turn OFF the Q1 switch 55
- How to ensure total power off 59
- Troubleshooting 61
- General status 62
- General fault 64
- Check that all power mod 65
- Module failure 66
- Threshold alarm 66
- Maintenance 69
- How to return parts to APC 70
- Replacement parts 70
- How to remove a power module 71
- How to install a power module 72
- How to remove a card 73
- How to install a card 73
- Battery replacement 74
- Adding Parts 75
- Add a circuit breaker 76
- Add a power cable 77
- Maintenance: Adding Parts 78
- Upgrading Firmware 79
- Specifications 81
- Product Information 87
- APC three-phase systems 88
- Obtaining service 89
- *990-1493* 92
Related products and manuals for Power supply units APC InfraStruXure Power Supply
Power supply units APC 208 VAC User Manual
(10 pages)
(10 pages)
Power supply units APC BX1300G User Manual
(20 pages)
(20 pages)
(15 pages)
Power supply units APC AP7622 User Manual
(28 pages)
(28 pages)
Power supply units APC 208 VAC User Manual
(25 pages)
(25 pages)
(30 pages)
Power supply units APC 10-30 KVA User Manual
(32 pages)
(32 pages)
Power supply units APC AP7820 User Manual
(12 pages)
(12 pages)
Power supply units APC S15 Specifications
(14 pages)
(14 pages)
© 2020, manymanuals.com. All rights reserved. | 0.860 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals