APC InfraStruXure Power Supply Specifications download pdf (Page 50)

Operation: Display Interface

44 InfraStruXure 20kW System: Installation, Operation, and Maintenance

Accessories screen

The Accessories screen is used only if the display interface is connected to the computer interface

port on the Display/Computer Interface card on the InfraStruXure 20kW System. From the

Accessories screen, you can view the status of APC accessories connected to the UPS.

Output Freq Set the desired output frequency.

Alarms Redundancy: The state of redundancy that will trigger an alarm.

Choices are:

• N+0—an alarm will occur only when there is more load than all

functioning power modules can support

• N+1—an alarm will occur when there are no spare power

modules in good condition

• N+2— an alarm will occur when there is only one functioning

power module

Load: When the load is greater than this threshold, an alarm will

sound.

Runtime: When the UPS is unable to power the load within the

parameters of the specified threshold, an alarm will sound. This alarm

is the result of an increase in load or a decrease in battery capacity.

Bypass Set the conditions that will automatically transfer the UPS into bypass

operation.

Copy Copy the UPS settings.

Other Self Test: Set the UPS to perform a self-test automatically at periodic

intervals.

UPS ID: Provide a unique name for the UPS.

VoutReporting: Set the reporting to the number of the tap to which the

most significant load is wired on the output transformer.

Output: Set the UPS output voltage.

BatFrAmpHour: Set the Amp-hour rating of external battery

enclosures that are not APC Symmetra XR Battery Enclosures.

1 2 ... 45 46 47 48 49 50 51 52 53 54 55 ... 91 92

No comments

APC InfraStruXure Power Supply Specifications Page 50