APC IP DSLAM User's Guide Page 335

  • Download
  • Add to my manuals
  • Print
  • Page
    / 603
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 334
327
Duplex auto|half|full
This parameter defines the modes, in which the
Ethernet Interface can come up. It can be
configured as ‘auto’, ‘half’, ‘full duplex’ or a
combination of these. Based on the values
configured, the Ethernet interface negotiates
with the peer entity.
Type : optional
Valid values: auto, half, full
Default value: auto
Pkttype
Mcast|Bcast|UnknownUc
ast | All|None
This parameter defines the packet type
supported by the interface.
‘etherPktTypeSupported’ shall be configured for
every Ethernet interface. By default, all packets
will be transmitted. The interface shall not
transmit any other packet type than that
configured.
Type: Create - optional
Modify - optional
Valid values : Mcast, Ucast, UnknownUcast,
All
Default Value: All
Orl decvalue
This parameter specifies the output rate limiting
value to be applied on this Interface. The unit for
the same is in Mbits/sec.
Type: Create - Optional
Modify - Optional
Valid Values: 1 -100
Default Value: 100
ProfileName
<profilename-val>
This parameter specifies the scheduling profile
to be associated with the Ethernet interface.
Type : Optional.
Default Value : SPROFILE
mgmtvlanid
<mgmtvlanid>
This parameter specifies the VLAN (C-Vlan) for
management traffic on this interface. Non-zero
value of this field is valid only if either 'ip' field is
non-zero or 'usedhcp' field is true. If no
Management VLAN id is specified (in the create
operation) or its value is set to zero (either in
create or modify operation), then the system
shall use the value of 'portvlanid' associated with
the bridge port created on this interface as the
Management VLAN Index. In case the
management VLAN (i.e. 'mgmtvlanid' or the
associated 'portvlanid', if 'mgmtvlanid' is zero)
does not exist on the system, then IP-based
management on this management VLAN shall
not happen on the interface till the
corresponding VLAN is created with the Net-side
port as its member. In stacked-VLAN mode, the
VLAN filtering mentioned above is based on
virtual-VLAN mapped to C-Vlan and S-Vlan for
the frame.
Type : Create - optional
Modify - optional
Valid values: 0 -4095
Page view 334
1 2 ... 330 331 332 333 334 335 336 337 338 339 340 ... 602 603

Comments to this Manuals

No comments