Chapter 6:
[sPDUMasterConfigVM] Master Configuration OIDs
PowerNet MIB Reference Guide
46
OID Task
sPDUMasterConfigVMTableSize
The number of MasterSwitch VM units.
{sPDUMasterConfigVMTable}
{sPDUMasterConfigVMEntry}
sPDUMasterConfigVMIndex
sPDUMasterConfigVMName
sPDUMasterConfigVMColdstartDelay
sPDUMasterConfigVMAudioAlarmActivated
sPDUMasterConfigVMHighLoadWarningThreshold
sPDUMasterConfigVMLowLoadWarningThreshold
sPDUMasterConfigVMOverloadRestriction
View and configure a specified MasterSwitch VM unit.
• The index to the MasterSwitch VM unit
’s entry (read-only).
• Define a name (up to 23 characters) for the MasterSwitch
VM unit.
• Define the delay that will occur from the time that power is
applied to the MasterSwitch VM unit until it supplies power
to its outlets:
- -1: Never start providing output power automatically.
- 0: Begin providing output power immediately.
- 15: 15-second delay
- 20: 20-second delay
- 30: 30-second delay
- 45: 45-second delay
- 60: 1-minute delay
- 120: 2-minute delay
- 300: 5-minute delay
• Define the following by using a SET:
- audioAlarmActiveNever (1): Disable the audio alarm.
- audioAlarmActiveOnOverload (2): Cause the audio
alarm to sound when an overload condition occurs.
-
audioAlarmActiveOnOverloadImminent (3): Cause the
audio alarm to sound when the load on the MasterSwitch
VM unit exceeds the high load warning threshold, as
defined by the
sPDUMasterConfigVMHighLoadWarningThreshold OID.
• Define the threshold that indicates when the power
consumption of the load is approaching an overload
condition. The value is specified as a percentage of a full
load.
• Define the threshold that indicates when the power
consumption of the load is approaching a low-consumption
condition. The value is specified as a percentage of a full
load.
• Control the behavior of the MasterSwitch VM unit when an
overload condition is imminent and a request has been made
to turn on additional outlets.
- alwaysAllowTurnOn (1): Always allow the outlets to
turn on.
- restrictOnWarning (2): Do not allow outlets to turn on if
the OID value specified for the High Load Warning
Threshold is exceeded.
- restrictOnOverload (3): Do not allow outlets to turn on
if the MasterSwitch VM unit is in an overload condition
Comments to this Manuals